Search arXivSearch

arXiv · 0706.0796

Continuous loading of $^{1}$S$_{0}$ calcium atoms into an optical dipole trap

Abstract

We demonstrate an efficient scheme for continuous trap loading based upon spatially selective optical pumping. We discuss the case of $^{1}$S$_{0}$ calcium atoms in an optical dipole trap (ODT), however, similar strategies should be applicable to a wide range of atomic species. Our starting point is a reservoir of moderately cold ($\approx 300 \mu$K) metastable $^{3}$P$_{2}$-atoms prepared by means of a magneto-optic trap (triplet-MOT). A focused 532 nm laser beam produces a strongly elongated optical potential for $^{1}$S$_{0}$-atoms with up to 350 $\mu$K well depth. A weak focused laser beam at 430 nm, carefully superimposed upon the ODT beam, selectively pumps the $^{3}$P$_{2}$-atoms inside the capture volume to the singlet state, where they are confined by the ODT. The triplet-MOT perpetually refills the capture volume with $^{3}$P$_{2}$-atoms thus providing a continuous stream of cold atoms into the ODT at a rate of $10^7 $s$^{-1}$. Limited by evaporation loss, in 200 ms we typically load $5 \times 10^5$ atoms with an initial radial temperature of 85 $\mu$K. After terminating the loading we observe evaporation during 50 ms leaving us with $10^5$ atoms at radial temperatures close to 40 $\mu$K and a peak phase space density of $6.8 \times 10^{-5}$. We point out that a comparable scheme could be employed to load a dipole trap with $^{3}$P$_{0}$-atoms.

Explore related subjects

Keep this discovery

BibTeXRIS

C. Y. Yang, P. Halder, O. Appel, D. Hansen, A. Hemmerich. 2007-06-06. Continuous loading of $^{1}$S$_{0}$ calcium atoms into an optical dipole trap. https://doi.org/10.1103/physreva.76.033418

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Delay-engineered dynamical phases in a programmable non-Markovian spin oscillator

Non-Markovian dynamics offer a new route towards engineering non-equilibrium matter, where memory and feedback act as programmable resources for controlling order in time. Here we report the realization of a non-Markovian spin oscillator in a hot vapour $^{129}$Xe-Cs co-magnetometer with programmable feedback delay and gain. By tuning these parameters, we observe a hierarchy of dynamical phases, including time-crystalline response, nonlinear bifurcations, and frequency-comb formation. The measured spectra and phase boundaries are captured by linear stability analysis of delayed Bloch equations, revealing these phenomena as different manifestations of the same memory-induced instability structure. These results establish time-delayed feedback as a powerful strategy for controlling non-equilibrium phases, enabling quantum sensing, frequency referencing, and synchronization within a single spin-based platform.

physics.atom-ph

Non-stick vacuum wall collisions with a laser-coolable molecule

Molecular species that are suitable for direct laser cooling are typically considered lost or destroyed if they collide with an ambient temperature vacuum wall. Here, we study surface collisions with aluminum monofluoride (AlF), a laser-coolable molecule that survives this process with unusually high probability. We detect the outgoing AlF molecules from a single wall collision via Doppler-sensitive laser-induced fluorescence spectroscopy, using incoming supersonic (pulsed) and thermochemical (continuous) molecular beams. The angular, velocity and rovibrational level distributions of the outgoing molecules show near-complete thermalisation to the wall in a single collision event. We determine an upper limit to the surface residence time of about 5$~\mu$s, and by monitoring the decay in density of pulses of molecules loaded into a small storage volume, we deduce the surface sticking probability for different materials. For a siloxane-coated metallic surface, the sticking probability of AlF is about 0.015, allowing us to accumulate molecules from the thermochemical source into an ambient temperature storage vessel at densities near $10^{8}~$cm$^{-3}$. This provides a route to compact, portable traps for neutral molecules.

physics.atom-ph

Kinetic modeling of molecular beam formation in a cryogenic buffer-gas cell

Cryogenic buffer-gas cells are widely used to produce cold molecular beams, but the microscopic dynamics governing beam formation remain challenging to model. Here we present fully kinetic simulations of a cryogenic buffer-gas cell using the Direct Simulation Monte Carlo method implemented in the PICLas framework, treating the buffer gas and ablated molecules within a single unified model. We capture characteristic features of cryogenic buffer-gas sources, including plume cooling, directed transport toward the aperture, and the formation of a slow molecular beam, while also resolving energy transfer from the hot ablation plume to the helium buffer gas that is inaccessible to existing approaches relying on the background-gas approximation. Our results demonstrate that fully kinetic simulations can provide detailed insights into buffer-gas cell dynamics and open a route toward a systematic optimization of such sources.

physics.atom-ph