Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 1007.5056

Conducting Atomic Force Microscopy Studies of Nanoscale Cobalt Silicide Schottky Barriers on Si(111) and Si(100)

Joseph L. Tedesco·J. E. Rowe·Robert J. Nemanich
View original source ↗Read source document ↗Export metadata ↓

Abstract

Cobalt silicide (CoSi2) islands have been formed by the deposition of thin films (~0.1 to 0.3 nm) of cobalt on clean Si(111) and Si(100) substrates in ultrahigh vacuum (UHV) followed by annealing to ~880 degrees C. Conducting atomic force microscopy has been performed on these islands to characterize and measure their current-voltage (I-V) characteristics. Current-voltage curves were analyzed using thermionic emission theory to obtain the Schottky barrier heights and ideality factors between the silicide islands and the silicon substrates. Current-voltage measurements were performed ex situ for samples ("passivated surfaces") where the silicon surface surrounding the islands was passivated with a native oxide. Other samples ("clean surfaces") remained in UHV while I-V curves were recorded. By comparing barrier heights and ideality factors for islands on both surfaces, the effects of the non-passivated surfaces on conduction were studied. The clean surface barrier heights were found to be ~0.2 to 0.3 eV below barrier heights measured from similar islands on passivated surfaces. The reduced Schottky barrier is mainly attributed to Fermi level pinning by non-passivated surface states of the clean silicon surface. However, the measured barrier heights of the clean surface islands are equivalent on both Si(111) and Si(100), suggesting that the non-passivated surfaces are influenced by cobalt impurities. Furthermore, the barrier heights of islands on the clean surfaces are lower than due to Fermi level pinning alone and the additional barrier height lowering is primarily attributed to spreading resistance effects. Schottky barrier inhomogeneity may also cause additional barrier height lowering and non-ideality in the contacts. The clean surface barrier heights decreased and the ideality factors increased with decreasing temperature, which is attributed to the temperature variation of the Fermi level.

Explore related subjects

cond-mat.mes-hall

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Joseph L. Tedesco, J. E. Rowe, Robert J. Nemanich. 2010-07-28. Conducting Atomic Force Microscopy Studies of Nanoscale Cobalt Silicide Schottky Barriers on Si(111) and Si(100). https://doi.org/10.1063/1.3100212

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Inverse Purcell Suppression of Decoherence in Majorana Qubits via Environmental Engineering

We show that the electromagnetic or phononic environment of a topological quantum device can be engineered to actively suppress decoherence. For a Majorana qubit in a superconducting wire, the exponentially small splitting $ε\sim e^{-L/ξ}$ that provides topological protection also makes the qubit vulnerable to low-frequency noise. From a microscopic local interaction, we derive the effective low-energy coupling between the Majorana parity operator and a bosonic field; the coupling strength itself is proportional to $ε$, reflecting the qubit's non-local nature. The resulting pure-dephasing rate scales as $Γ_ϕ\propto ε^2 S(ε)$, with $S(ε)$ the environmental noise power at frequency $ε$. In the experimentally relevant high-temperature regime ($k_B T \gtrsim \hbarε$), this gives $Γ_ϕ\propto ερ(ε) T$, where $ρ(ε)$ is the environmental density of states. By engineering an environment with a suppressed low-frequency density of states, $ρ_{\text{eng}}(ω) = ρ_0 (ω/ω_c)^α$ for $ω< ω_c$ ($α> 0$), the dephasing rate drops to $Γ_ϕ^{\text{eng}} \propto ε^{α+1} \propto e^{-(α+1)L/ξ}$. Thus, longer wires yield exponentially better coherence---a direct synergy with topological protection. This "inverse Purcell" effect, which suppresses the density of states at the qubit frequency, provides a quantitative design principle for environmental engineering. Our work establishes spectral density shaping as a practical method for enhancing coherence in topological quantum devices.

cond-mat.mes-hall↗
arXiv2026

Axionic tunneling from a topological Kondo insulator

Discoveries over the past two decades have revealed the remarkable ability of quantum materials to emulate relativistic properties of the vacuum, from Dirac cones in graphene to Dirac surface states of topological insulators. Yet one of the most elusive consequences of topology in quantum matter -- the axionic ${\bf E}\cdot{\bf B}$ contribution to the electromagnetic response, predicted to produce strong magnetoelectric effects -- remains experimentally challenging to detect. Here we report evidence for an axion-like magnetoelectric response obtained through scanning tunneling microscopy (STM) using a SmB$_6$ nanowire tip on an antiferromagnetic Fe$_{1+x}$Te sample. Our measurements reveal a striking voltage-induced magnetization: millivolt biases generate measurable tip magnetizations that reverse with the voltage. The magnitude, tunability, and reversibility of this signal are consistent with an axion-like ${\bf E} \cdot {\bf B}$ coupling, which naturally accounts for the voltage-odd magnetic component of the tip spectral function while strongly constraining a conventional static-magnetism interpretation. Moreover, millivolt-scale control of spin polarization in a tunnel junction provides a new route for probing axionic electrodynamics and opens avenues for future STM and spintronic applications.

cond-mat.mes-hall↗
arXiv2026

Exciton-mediated optical control of liquid-solid friction

Interfacial friction in nanofluidic systems can arise from fluctuation-induced coupling between liquid charge fluctuations and the internal excitations of the confining solid. Here, we develop a microscopic theory of exciton-mediated solid-liquid friction based on the coupling between optically generated excitons and charge fluctuations in water. We distinguish between static excitons, localized by disorder or functionalization, and dynamic excitons, which interact with water through polarization fluctuations. In both cases, we derive analytical formulas for the excitonic friction, which is experimentally tunable and can significantly reduce the slip length and thereby the hydraulic permeability of nanochannels. Applying our framework to carbon nanotubes, we quantitatively reproduce the recent measurements of Kistwal et al., showing a reduction of nanotube diffusion under optical excitation, without fitting parameters. More broadly, our results establish excitons as a mechanism to optically control nanofluidic transport and suggest that excitonic photoluminescence could provide an optical probe of flow velocity inside nanochannels.

cond-mat.mes-hall↗