Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 1109.4333

Influence of Strand Design, Boron Type, and Carbon Doping Method on the Transport Properties of Powder-in-Tube MgB2-XCX Strands

Y. Yang·M. Susner·M. D. Sumption·M. Rindfleisch·M. Tomsic·E. W. Collings
View original source ↗Read source document ↗Export metadata ↓

Abstract

The transport properties of a number of MgB2 strands have been investigated in terms of their response to strand design, starting B powder choice, and the approach to C doping used. The strands had various designs, specifically; (i) several chemical barriers were introduced, viz: Fe and Nb, (ii) the strands were encased in various outer-sheath materials, viz.: monel, Cu+monel, monel+glidcop, Nb+monel, (iii) the filament counts were varied (1, 18, and 36), and (iv) the final strand diameter was varied. In addition, for a subset of the strand designs several B powder and C-dopant types were investigated. Specifically, two types of amorphous B powder were used: (i) Moissan based "Tangshan boron" (ii) "SMI-boron" which is produced in a plasma torch by the reduction-by-hydrogen of BCl3. Two approaches to C doping were taken: (i) "malic-acid treatment" in which C is introduced into the B powder precursor by the moderate temperature drying out a slurry of B mixed in with a malic-acid-toluene solution (during which the malic acid decomposes leaving C as the only solid residue) before the Mg powder is mixed in; (ii) direct C doping of the SMI-produced B by introducing a known percentage of CH4 into the plasma flame. Critical current densities, Jc, were measured on 1.5 m long samples at 4.2 K in fields of up to 14 T; of all the strands measured, that doped with SMI-C at a nominal 4 mol% C (in relation B) yielded the highest Jc values e.g 1.1x105 A/cm2 at 7 T, 4.5x104 at 10 T, and 2.2x104 A/cm2 at 12 T. The n-values are given for all strands at 5 and 10 T, and for a certain set of strands the magnetic field dependencies of the n-values and the influence of C-doping is presented. Finally we demonstrate that, over a wide range of B, log(Jc) decreases linearly with B with a slope -{\alpha} such that the Jc(B) of any strand can be parameterized in terms of {\alpha} and its zero-field intercept Jc(B=0).

Explore related subjects

cond-mat.supr-con

Keep this discovery

BibTeXRIS

Y. Yang, M. Susner, M. D. Sumption, M. Rindfleisch, M. Tomsic, E. W. Collings. 2011-09-20. Influence of Strand Design, Boron Type, and Carbon Doping Method on the Transport Properties of Powder-in-Tube MgB2-XCX Strands. https://doi.org/10.1109/tasc.2012.2184539

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Out-of-equilibrium relaxation dynamics of the superconducting order parameter in CsV$_3$Sb$_5$

The application of a time-varying strain field drives a superconducting order parameter out of equilibrium. How the order parameter relaxes back to equilibrium depends both on the structure of the superconducting gap and on the nature of quasiparticle scattering. We report the discovery of an ultrasonic attenuation peak inside the superconducting state of the kagome superconductor CsV$_3$Sb$_5$. This peak is the natural consequence of the order parameter relaxation time matching the ultrasonic drive frequency near $T_{\rm c}$. From the measured frequency dependence of the peak, we extract a microscopic scattering time of $\tau_N = 25$ ps. This timescale is two orders of magnitude longer than the elastic scattering time as determined by resistivity measurements, but is comparable to the inelastic scattering time determined by thermal transport. Within the conventional framework of order-parameter relaxation, this implies that elastic scattering is ineffective at relaxing the superconducting condensate, consistent with a sign-preserving $s$-wave state obeying Anderson's theorem.

cond-mat.supr-con↗
arXiv2026

Eight-unit-cell electronic modulations in cuprates originating from local molecular orbitals

The pair density wave (PDW) state with eight-unit-cell (8a0) periodicity has been widely regarded as the primary order in cuprates, yet its existence and origin remain subjects of intense debate. Using spectroscopic imaging scanning tunneling microscopy, we observe spatial modulations of the electronic states with approximately 8a0 periodicity in both the superconducting and insulating regimes of hole-doped Ca2CuO2Cl2 cuprate. We find that the 8a0 spatial patterns are generated by the formation of molecular orbitals by doped holes, which organize into 4a0*4a0 plaquettes as the basic unit. Our results identify the 4a0 molecular orbital as the fundamental electronic building block in cuprates, while the 8a0 PDW represents a spatial subharmonic that emerges at sufficiently high doping.

cond-mat.supr-con↗
arXiv2026

Record-Breaking Elemental Superconductivity in Tetralayer Kagome Borophene

Superconductivity above the liquid-nitrogen temperature remains rare in two-dimensional elemental crystals, where strong covalent bonding often yields high phonon frequencies but insufficient electron-phonon coupling. Here, using first-principles calculations and fully anisotropic Migdal-Eliashberg theory, we predict tetralayer kagome borophene (TKB) stabilized by ABAB covalent stacking, as a liquid-nitrogen-temperature elemental superconductor. With a predicted critical temperature of 102 K, TKB sets a record-high value among previously reported elemental superconductors. Unlike known high-Tc boron-based superconductors dominated by in-plane sigma-bonding states and high-frequency in-plane B-B stretching modes, TKB realizes an out-of-plane s-pz-bonding-mediated pairing mechanism, in which interlayer s-pz bonding states at the Fermi level are strongly coupled to low-frequency out-of-plane vibrations of boron atoms. These results reveal a distinct out-of-plane pairing channel in multilayer borophene and establish covalent stacking engineering as a potential route for high-Tc superconductivity in two-dimensional materials.

cond-mat.supr-con↗