Search arXivSearch

arXiv · 1202.3603

Solitary magnetic perturbations at the ELM onset

Abstract

Edge localised modes (ELMs) allow maintaining sufficient purity of tokamak H-mode plasmas and thus enable stationary H-mode. On the other hand in a future device ELMs may cause divertor power flux densities far in excess of tolerable material limits. The size of the energy loss per ELM is determined by saturation effects in the non-linear phase of the ELM, which at present is hardly understood. Solitary magnetic perturbations (SMPs) are identified as dominant features in the radial magnetic fluctuations below 100kHz. They are typically observed close (+-0.1ms) to the onset of pedestal erosion. SMPs are field aligned structures rotating in the electron diamagnetic drift direction with perpendicular velocities of about 10km/s. A comparison of perpendicular velocities suggests that the perturbation evoking SMPs is located at or inside the separatrix. Analysis of very pronounced examples showed that the number of peaks per toroidal turn is 1 or 2, which is clearly lower than corresponding numbers in linear stability calculations. In combination with strong peaking of the magnetic signals this results in a solitary appearance resembling modes like palm tree modes, edge snakes or outer modes. This behavior has been quantified as solitariness and correlated to main plasma parameters. SMPs may be considered as a signature of the non-linear ELM-phase originating at the separatrix or further inside. Thus they provide a handle to investigate the transition from linear to non-linear ELM phase. By comparison with data from gas puff imaging processes in the non-linear phase at or inside the separatrix and in the scrape-off-layer (SOL) can be correlated. A connection between the passing of an SMP and the onset of radial filament propagation has been found. Eventually the findings related to SMPs may contribute to a future quantitative understanding of the non-linear ELM evolution.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

RP Wenninger, H Zohm, JE Boom, A Burckhart, MG Dunne, R Dux, T Eich, R Fischer, C Fuchs, M Garcia-Munoz, V Igochine, M Hoelzl, NC Luhmann Jr, T Lunt, M Maraschek, HW Mueller, HK Park, PA Schneider, F Sommer, W Suttrop, E Viezzer, the ASDEX Upgrade Team. 2012-02-16. Solitary magnetic perturbations at the ELM onset. https://doi.org/10.1088/0029-5515%2F52%2F11%2F114025

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Mechanism of Ionization Avalanche in Tokamak Microwave Gas Breakdown

Microwave breakdown driven by electron cyclotron (EC) waves provides a non-inductive route to plasma initiation in reactor-scale tokamaks. We introduce a three-dimensional Monte Carlo simulation that, for the first time, self-consistently treats nonlinear wave-particle interactions, atomic collisions, and guiding-center transport. The Monte Carlo simulation unveils the key role of parallel Brownian motion in the ionization avalanche mechanism. The predicted breakdown boundary is validated against KSTAR experiments. This work concludes that microwave gas breakdown will be successful under ITER-relevant conditions at a D$_2$ prefill pressure near 2 mPa with 1 MW of injected EC power.

physics.plasm-ph

Augmented reality system for visualising magnetic field topology and charged-particle trajectories in magnetic fusion plasmas

A cost-effective augmented reality (AR) system is presented for visualising three-dimensional magnetic field structures and charged-particle trajectories in magnetically confined fusion plasmas. The system presented in this study integrates an orbit-following simulation code with a marker-based AR framework using a web camera and the OpenCV library. By synchronizing the time step of the simulation with the frame rate of the camera, the trajectories are continuously updated and superimposed in real time onto the camera image. Through the interactive operation of manipulating the web camera, users can observe three-dimensional structures, such as magnetic islands, from various positions and viewing angles. Such an AR environment supports an interactive means of exploring three-dimensional spatial structures that can be difficult to interpret from two-dimensional representations alone. It also provides a common visual representation that can be shared through a display by researchers and students with diverse backgrounds in physics, engineering, and related fields. The developed system has been used in practical exercises at the JT-60SA International Fusion School, with exploratory feedback from students.

physics.plasm-ph

Sensitivity of a low-shear heliotron configuration to localised ferrite-steel perturbations

The influence of ferritic steel on low-shear stellarator/heliotron magnetic configurations is investigated for the Heliotron J device using a point dipole magnetisation model. By numerically evaluating ferritic steel plates assumed at several locations inside the Heliotron J vacuum vessel, the changes in the rotational transform and magnetic island width are shown to be sensitive to the installation location. This location sensitivity arises from the toroidal variation of poloidal mode coupling between the background nonaxisymmetric field and ferritic-steel perturbation, rather than being determined solely by the perturbation amplitude. The resulting mode coupling can enhance the resonant vacuum magnetic perturbation at specific locations. Ferritic steel plates placed on the outer side of a straight section produce the most significant changes in the magnetic topology and exhibit the highest sensitivity to violations of the $M=4$ toroidal periodicity. Additionally, we show that appropriate arrangements of passive magnetic dipoles can reduce the effective helical ripple while preserving the vacuum magnetic well depth in Heliotron J, and can induce a stellarator-asymmetric boundary perturbation in low-field experiments.

physics.plasm-ph