Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 1503.06466

Is the Low-Complexity Mobile-Relay-Aided FFR-DAS Capable of Outperforming the High-Complexity CoMP?

Shaoshi Yang·Xinyi Xu·Dimitrios Alanis·Soon Xin Ng·Lajos Hanzo
View original source ↗Read source document ↗Export metadata ↓

Abstract

Coordinated multi-point transmission/reception aided collocated antenna system (CoMP-CAS) and mobile relay assisted fractional frequency reuse distributed antenna system (MR-FFR-DAS) constitute a pair of virtual-MIMO based technical options for achieving high spectral efficiency in interference-limited cellular networks. In practice both techniques have their respective pros and cons, which are studied in this paper by evaluating the achievable cell-edge performance on the uplink of multicell systems. We show that assuming the same antenna configuration in both networks, the maximum available cooperative spatial diversity inherent in the MR-FFR-DAS is lower than that of the CoMP-CAS. However, when the cell-edge MSs have a low transmission power, the lower-complexity MR-FFR-DAS relying on the simple single-cell processing may outperform the CoMP-CAS by using the proposed soft-combining based probabilistic data association (SC-PDA) receiver, despite the fact that the latter scheme is more complex and incurs a higher cooperation overhead. Furthermore, the benefits of the SC-PDA receiver may be enhanced by properly selecting the MRs' positions. Additionally, we show that the performance of the cell-edge MSs roaming near the angular direction halfway between two adjacent RAs (i.e. the "worst-case direction") of the MR-FFR-DAS may be more significantly improved than that of the cell-edge MSs of other directions by using multiuser power control, which also improves the fairness amongst cell-edge MSs. Our simulation results show that given a moderate MS transmit power, the proposed MR-FFR-DAS architecture employing the SC-PDA receiver is capable of achieving significantly better bit-error rate (BER) and effective throughput across the entire cell-edge area, including even the "worst-case direction" and the cell-edge boundary, than the CoMP-CAS architecture.

Explore related subjects

cs.ITmath.IT

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Shaoshi Yang, Xinyi Xu, Dimitrios Alanis, Soon Xin Ng, Lajos Hanzo. 2015-04-17. Is the Low-Complexity Mobile-Relay-Aided FFR-DAS Capable of Outperforming the High-Complexity CoMP?. https://doi.org/10.1109/tvt.2015.2416333

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Bistatic Target Detection by Exploiting Both Deterministic Pilots and Unknown Random Data Payloads

Integrated sensing and communication (ISAC) plays a crucial role in 6G, to enable innovative applications such as drone surveillance, urban air mobility, and low-altitude logistics. However, the hybrid ISAC signal, which comprises deterministic pilot and random data payload components, poses challenges for target detection due to two reasons: 1) these two components cause coupled shifts in both the mean and variance of the received signal, and 2) the random data payloads are typically unknown to the sensing receiver in the bistatic setting. Unfortunately, these challenges could not be tackled by existing target detection algorithms. In this paper, a generalized likelihood ratio test (GLRT)-based detector is derived, by leveraging the known deterministic pilots and the statistical characteristics of the unknown random data payloads. Due to the analytical intractability of exact performance characterization, we perform an asymptotic analysis for the false alarm probability and detection probability of the proposed detector. The results highlight a critical trade-off: both deterministic and random components improve detection reliability, but the latter also brings statistical uncertainty that hinders detection performance. Simulations validate the theoretical findings and demonstrate the effectiveness of the proposed detector, which highlights the necessity of designing a dedicated detector to fully exploited the signaling resources assigned to random data payloads.

cs.IT↗
arXiv2026

On Unbiased Parameter Estimation and Signal Reconstruction

In this paper, we extend the theory of depth-unbiased source localization to unbiased parameter estimation and signal reconstruction for an arbitrary number of non-zero parameters. The topic touches on exact reconstructibility, most commonly studied in compressed sensing and multisource estimation across various imaging problems. The theoretical results derive upper bounds on the number of recoverable parameters in the noiseless case, and define a probability measure to assess the likelihood of recovering all non-zero parameters with correct magnitude order. The work provides a mathematical explanation of the open question regarding the noise robustness of standardized and unbiased methods. The paper also reveals a trade-off between the number of sensors and the signal-to-noise ratio. Numerical experiments demonstrate the theoretical findings.

cs.IT↗
arXiv2026

Minimum enclosing Bregman balls made easy

In this work, we revisit the problem of computing minimum enclosing Bregman balls (Bregman MEBs) of finite sets of parameters. First, we show that Bregman MEBs are equivalent to MEBs of corresponding weighted point sets with respect to the power distance. We then report an efficient Frank--Wolfe $(1+ε)$-approximation algorithm for computing power MEBs, for any $ε>0$. This power MEB approximation algorithm coincides with the Bregman MEB approximation algorithm of Nock and Nielsen (2005) when expressed in the dual gradient space. Finally, we show that the Bregman potential lifting transforms used to construct Bregman Voronoi diagrams can be reinterpreted as the classical paraboloid lifting transform applied to corresponding weighted point sets. In particular, Bregman MEB circumcenters lie on the farthest Bregman Voronoi diagrams or equivalently on the corresponding farthest power diagrams.

cs.IT↗