Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 2112.05564

Identification of Hip and Knee Joint Impedance During the Swing Phase of Walking

Herman van der Kooij·Simone S. Fricke·Ronald C. van 't Veld·Ander Vallinas Prieto·Arvid Q. L. Keemink·Alfred C. Schouten·Edwin H. F. van Asseldonk
View original source ↗Read source document ↗Export metadata ↓

Abstract

Knowledge on joint impedance during walking in various conditions is relevant for clinical decision-making and the development of robotic gait trainers, leg prostheses, leg orthotics and wearable exoskeletons. Whereas ankle impedance during walking has been experimentally assessed, knee and hip joint impedance during walking have not been identified yet. Here we developed and evaluated a lower limb perturbator to identify hip, knee and ankle joint impedance during treadmill walking. The lower limb perturbator (LOPER) consists of an actuator connected to the thigh via rods. The LOPER allows to apply force perturbations to a free-hanging leg, while standing on the contralateral leg, with a bandwidth of up to 39 Hz. While walking in minimal impedance mode, the interaction forces between LOPER and the thigh were low (<5 N) and the effect on the walking pattern was smaller than the within-subject variability during normal walking. Using a non-linear multibody dynamical model of swing leg dynamics, the hip, knee and ankle joint impedance were estimated at three time points during the swing phase for nine subjects walking at a speed of 0.5 m/s. The identified model was well able to predict the experimental responses for the hip and knee, since the mean variance accounted (VAF) for was 99% and 96%, respectively. The ankle lacked a consistent response and the mean VAF of the model fit was only 77%, and therefore the estimated ankle impedance was not reliable. The averaged across-subjects stiffness varied between the three time points within 34-66 and 0-3.5 Nm/rad for the hip and knee joint respectively. The damping varied between 1.9-4.6 and 0.02-0.14 Nms/rad for hip and knee respectively. The developed LOPER has a negligible effect on the unperturbed walking pattern and allows to identify hip and knee impedance during the swing phase.

Explore related subjects

cs.ROcs.SYeess.SY

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Herman van der Kooij, Simone S. Fricke, Ronald C. van 't Veld, Ander Vallinas Prieto, Arvid Q. L. Keemink, Alfred C. Schouten, Edwin H. F. van Asseldonk. 2022-08-09. Identification of Hip and Knee Joint Impedance During the Swing Phase of Walking. https://doi.org/10.1109/tnsre.2022.3172497

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Humanoid Whole-Body Badminton via an Annealed Reinforcement Learning Curriculum

Humanoid robots have demonstrated strong capabilities for interacting with static scenes across locomotion and manipulation, yet dynamic real-world interactions remain challenging. As a step toward fast-moving object interactions, we present an RL training pipeline that yields a unified whole-body controller for humanoid badminton, coordinating footwork and striking without motion priors or expert demonstrations. In badminton, locomotion and striking are tightly coupled, making the final hitting objective difficult to optimize directly due to sparse rewards and conflicting gradients. We address this with an annealed curriculum that first stabilizes learning through auxiliary locomotion objectives, then progressively removes them to focus optimization on the final hitting objective. For deployment, we use an Extended Kalman Filter (EKF) to estimate and predict shuttlecock trajectories for target striking, and also develop a prediction-free variant that removes the EKF and explicit prediction. We validate the framework in simulation and on hardware. In simulation, two robots sustain a rally of 21 consecutive hits. In real-world tests with both machine-fed shuttles and human-robot rallies, the robot achieves outgoing shuttle speeds up to 19.1 m/s. Moreover, the prediction-free variant attains comparable performance to the EKF-based policy. Overall, our approach enables dynamic yet precise goal striking in humanoid badminton and suggests a path toward more dynamics-critical whole-body interaction tasks.

cs.RO↗
arXiv2026

CREPES-X: Hierarchical Bearing-Distance-Inertial Direct Cooperative Relative Pose Estimation System

Relative localization is essential for cooperation in autonomous multi-robot systems. Existing approaches either rely on shared environmental features or inertial assumptions, or they degrade under pairwise non-line-of-sight conditions and outliers in complex environments. Robustly and efficiently fusing inter-robot bearings, distances, and inertial measurements for tens of robots remains challenging. We present CREPES-X (Cooperative RElative Pose Estimation System with multiple eXtended features), a hierarchical relative localization framework that enhances speed, accuracy, and robustness under challenging conditions, without requiring any global information. The hardware packs infrared (IR) LEDs, an IR camera, an ultra-wideband module, and an IMU into a cube no larger than $6\,\text{cm}$ on each side. On this hardware, a two-stage hierarchical estimator meets different latency, accuracy, and robustness requirements. The single-frame estimator returns instantaneous relative poses from a closed-form solution with bearing outlier rejection. The multi-frame estimator then refines these poses with IMU pre-integration under robocentric relative kinematics, using loosely- and tightly-coupled optimization. Extensive simulations and real-world experiments validate the effectiveness of CREPES-X, demonstrating robustness of up to $90\%$ bearing outliers, resilience in challenging conditions, and RMSE of $7.0\,\text{cm}$ and $2.2^\circ$ in real-world datasets.

cs.RO↗
arXiv2026

SurfSLAM: Sim-to-Real Underwater Stereo Reconstruction For Real-Time SLAM

Localization and mapping are core perceptual capabilities for underwater robots. Stereo cameras provide a low-cost means of directly estimating metric depth to support these tasks. However, despite recent advances in stereo depth estimation on land, computing depth from image pairs in underwater scenes remains challenging. In underwater environments, images are degraded by light attenuation, visual artifacts, and dynamic lighting conditions. Furthermore, real-world underwater scenes frequently lack rich texture useful for stereo depth estimation and 3D reconstruction. As a result, stereo estimation networks trained on in-air data cannot transfer directly to the underwater domain. In addition, there is a lack of real-world underwater stereo datasets for supervised training of neural networks. Poor underwater depth estimation is compounded in stereo-based Simultaneous Localization and Mapping (SLAM) algorithms, making it a fundamental challenge for underwater robot perception. To address these challenges, we propose a novel framework that enables sim-to-real training of underwater stereo disparity estimation networks using simulated data and self-supervised finetuning. We leverage our learned depth predictions to develop SurfSLAM, a novel framework for real-time underwater SLAM that fuses stereo cameras with IMU, barometric, and Doppler Velocity Log (DVL) measurements. Lastly, we collect a challenging real-world dataset of shipwreck surveys using an underwater robot. Our dataset features over 24,000 stereo pairs, along with high-quality, dense photogrammetry models and reference trajectories for evaluation. Through extensive experiments, we demonstrate the advantages of the proposed training approach on real-world data for improving stereo estimation in the underwater domain and for enabling accurate trajectory estimation and 3D reconstruction of complex shipwreck sites.

cs.RO↗