Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 2310.07339

New strategies to improve the sensitivity of the ANAIS-112 experiment at the Canfranc Underground Laboratory

David Cintas
View original source ↗Read source document ↗Export metadata ↓

Abstract

The goal of the ANAIS-112 experiment, which operates at LSC, is to test in a model independent way the DAMA/LIBRA positive signal using the same target (NaI(Tl) crystals) and technique. Several strategies have been followed in this work to improve the sensitivity of the ANAIS-112 experiment. The Quenching Factor (QF) is a key factor in the comparison between different experiments. It has been determined both for iodine and sodium nuclear recoils in 5 crystals, for the first time in the same setup and using the same analysis protocol. Compatible values have been obtained for all of them. The calibration method in electron equivalent energy has proved to be critical in the QF estimation and allows understanding the discrepancies between previous measurements, but not concluding if the sodium QF is constant with energy or it increases up to about 80 keVnr. Therefore, further work is required to understand the conversion of the energy deposited in NaI(Tl) into light by different particles, as it is essential to develop a model for the QF. As a first step in an effort to understand the origin of some of the spurious event populations observed in the experiment, a GEANT4 simulation of an ANAIS-112 module has been developed including optical light emission and propagation after an energy deposit. Finally, the possibility of improving the sensitivity of NaI scintillators by replacing Photomultiplier Tubes with Silicon Photomultipliers as light sensors has been studied. These detectors offer very interesting opportunities within the new project ANAIS+. In this work we have characterized SiPMs from different manufacturers, established measurement protocols for the most relevant parameters, studied the properties of NaI and NaI(Tl) crystals at different temperatures and designed NaI+SiPM prototypes that will allow us to evaluate the limitations and opportunities of this new technology.

Explore related subjects

physics.ins-det

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

David Cintas. 2023-10-11. New strategies to improve the sensitivity of the ANAIS-112 experiment at the Canfranc Underground Laboratory. https://arxiv.org/abs/2310.07339

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

The Remote Analog to Digital Conversion DAQ System for the TRISTAN Detector Upgrade

The TRISTAN detector is an upgrade to the KATRIN experiment to enable a differential measurement of the tritium $β$-decay spectrum to search for sterile neutrinos with keV masses. This entails performing precision electron spectroscopy with over one thousand silicon drift detector pixels, each responsible for recording incident electron rates of $10^5$ counts per second. A project specific data acquisition (DAQ) system is developed to meet the experimental challenges through a remote analog to digital conversion (RADC) design. In this work, the conceptual design of the RADC DAQ is presented along with the built system for operating the TRISTAN detector upgrade. The system includes flexible signal processing logic and data management that is optimized for the high-rate precision measurement.

physics.ins-det↗
arXiv2026

True Alternating Current Scanning Tunneling Microscope (ACSTM): tunneling on insulators

Scanning Tunneling Microscopy (STM) has revolutionized our atomic scale understanding of surfaces and accelerated progress in nanotechnology. This technique, however, is restricted to metal or semiconducting samples, as it requires a tiny current to stabilize the tip-sample distance with atomic scale precision. We developed a new imaging and feedback method that relies on true alternating current (AC) without any direct current (DC) component. This technique does not only enable the imaging on non-conducting surfaces with atomic step resolution, like (thin) glass and oxides, it provides also access to high-frequency electronic signal coming from the sample. We demonstrate that it is possible to measure on 25nm thick silicon oxide with 10 MHz tunneling current.

physics.ins-det↗
arXiv2026

Charged-particle topology reconstruction with an in-liquid SiPM array

Liquid scintillator detectors instrumented with photosensors inside the scintillation volume preserve local optical information that is largely lost in conventional boundary-readout geometries. We demonstrate that this information is sufficient for charged-particle topology reconstruction using a sparse three-dimensional lattice of silicon photomultipliers. After validating the Geant4 detector response against measured photon-count distributions, a simulation-trained, time-informed convolutional neural network reconstructs the entry and exit points of through-going muons with median residuals of 1.91~cm and 2.39~cm, respectively. The reconstructed endpoints are geometrically consistent with acceptance regions defined by external trigger counters in cosmic-ray muon data. The same framework also reconstructs the production vertices of simulated positron starting-track events with a median residual of about 4.5~cm. These results establish the feasibility of topology-sensitive reconstruction using sparse in-liquid photosensor arrays in homogeneous liquid scintillator detectors.

physics.ins-det↗