Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 2402.07378

Combination of crystal growth with optical floating zone and evaluation of Nd3+:LaAlO3 crystals with the dynamic nuclear polarization of 139La and 27Al

Kohei Ishizaki·Ikuo Ide·Masaki Fujita·Hiroki Hotta·Yuki Ito·Masataka Iinuma·Yoichi Ikeda·Takahiro Iwata·Masaaki Kitaguchi·Hideki Kohri·Taku Matsushita·Daisuke Miura·Yoshiyuki Miyachi·Hirohiko M. Shimizu·Masaru Yosoi
View original source ↗Read source document ↗Export metadata ↓

Abstract

Producing a polarized lanthanum (La) target with high polarization and long relaxation time is crucial for realizing time-reversal violation experiments using polarized neutron beams. We use a LaAlO3 crystal doped with a small amount of Nd3+ ions for the polarized lanthanum target. Optimizing the amount of Nd3+ ions is considerably important because the achievable polarization and relaxation time strongly depend on this amount. We established a fundamental method to grow single crystals of Nd3+:LaAlO3 using an optical floating zone method that employs halogen lamps and evaluated the crystals with the dynamic nuclear polarization (DNP) method for polarizing nuclear spins. Two crystal samples were grown by ourselves and evaluated with the DNP at 1.3 K and 2.3 T for the first time except for the target materials of protons. The enhancement of NMR signals for 139La and 27Al was successfully observed, and the enhancement factors were eventually 3.5+-0.3 and 13+-3 for the samples with Nd3+ ions of 0.05 and 0.01 mol%, respectively. These enhancement factors correspond to absolute vector polarizations of 0.27+-0.02% (Nd 0.05 mol%) and 1.4+-0.3% (Nd 0.01 mol%). Although the obtained polarizations are still low, they are acceptable as a first step. The combination scheme of the crystal growth and evaluation of the crystals is found to be effectively applicable for optimizing the amount of Nd3+ ions for improving the performance of the polarized target.

Explore related subjects

physics.ins-det

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Kohei Ishizaki, Ikuo Ide, Masaki Fujita, Hiroki Hotta, Yuki Ito, Masataka Iinuma, Yoichi Ikeda, Takahiro Iwata, Masaaki Kitaguchi, Hideki Kohri, Taku Matsushita, Daisuke Miura, Yoshiyuki Miyachi, Hirohiko M. Shimizu, Masaru Yosoi. 2024-05-01. Combination of crystal growth with optical floating zone and evaluation of Nd3+:LaAlO3 crystals with the dynamic nuclear polarization of 139La and 27Al. https://arxiv.org/abs/2402.07378

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

True Alternating Current Scanning Tunneling Microscope (ACSTM): tunneling on insulators

Scanning Tunneling Microscopy (STM) has revolutionized our atomic scale understanding of surfaces and accelerated progress in nanotechnology. This technique, however, is restricted to metal or semiconducting samples, as it requires a tiny current to stabilize the tip-sample distance with atomic scale precision. We developed a new imaging and feedback method that relies on true alternating current (AC) without any direct current (DC) component. This technique does not only enable the imaging on non-conducting surfaces with atomic step resolution, like (thin) glass and oxides, it provides also access to high-frequency electronic signal coming from the sample. We demonstrate that it is possible to measure on 25nm thick silicon oxide with 10 MHz tunneling current.

physics.ins-det↗
arXiv2026

Charged-particle topology reconstruction with an in-liquid SiPM array

Liquid scintillator detectors instrumented with photosensors inside the scintillation volume preserve local optical information that is largely lost in conventional boundary-readout geometries. We demonstrate that this information is sufficient for charged-particle topology reconstruction using a sparse three-dimensional lattice of silicon photomultipliers. After validating the Geant4 detector response against measured photon-count distributions, a simulation-trained, time-informed convolutional neural network reconstructs the entry and exit points of through-going muons with median residuals of 1.91~cm and 2.39~cm, respectively. The reconstructed endpoints are geometrically consistent with acceptance regions defined by external trigger counters in cosmic-ray muon data. The same framework also reconstructs the production vertices of simulated positron starting-track events with a median residual of about 4.5~cm. These results establish the feasibility of topology-sensitive reconstruction using sparse in-liquid photosensor arrays in homogeneous liquid scintillator detectors.

physics.ins-det↗
arXiv2026

Characterization of immersed SiPM arrays in liquid scintillator between room temperature and $-30\,^{\circ}\mathrm{C}$

Liquid scintillator detectors instrumented with distributed silicon photomultiplier (SiPM) arrays can be used in compact, topology-sensitive, and low-background experiments, but the temperature dependence of SiPMs immersed directly in the scintillation medium has not been widely characterized. We report the operation of a 125-liter linear-alkylbenzene-based liquid scintillator detector read out by 125 SiPM channels immersed in the active volume, over the range from room temperature to $-30\,^{\circ}\mathrm{C}$. The detector response was measured with cosmic-ray muons, including stopping muons followed by their Michel-electron decay. Cooling from $+15\,^{\circ}\mathrm{C}$ to $-30\,^{\circ}\mathrm{C}$ reduced the SiPM dark-count rate by a factor of 13.5, increased the single-photoelectron response by 49.1%, and increased the cosmic-ray muon light yield by 16.7%. The improved photoelectron separation and baseline stability at low temperature enabled a selection of stopping-muon events, from which the effective muon lifetime was measured to be $1959\pm132\,\mathrm{ns}$, consistent with the value expected for a hydrocarbon scintillator once $μ^{-}$ capture on carbon is taken into account.

physics.ins-det↗