Search arXivSearch

arXiv · 2608.01756

Deterministic DTFT Interpolation for Joint Frequency and Chirp-Rate Estimation: Cell-Uniform Efficiency and Threshold Analysis

Abstract

Joint frequency and chirp-rate estimation for a noisy chirp signal arises in radar, sonar, and burst satellite communications. Conventional estimators combine a coarse grid search with fine interpolation; accuracy degrades at the edges of the residual cell (the edge effect) and below the breakdown SNR (the threshold effect). We present a deterministic two-stage estimator that controls both failure modes uniformly over the residual cell. The estimator combines a time-centered, zero-padded dechirp-FFT acquisition bank with alternating selectable-$p$ amplitude-interpolation refinements on DTFT samples at fractional bins; in the centered frame, the frequency-chirp-rate cross-term of the Fisher information vanishes. The paper derives a mean-squared-error and threshold characterization over the full SNR range, in closed form except for one calibrated scalar (an effective cell count), to our knowledge the first for the joint problem: the breakdown threshold is governed by the cell count, and its cell-position dependence is dominated by the scalloping loss of the coarse FFT, which the padding bounds at 0.4 dB. An asymptotic uniformity analysis over the cell, including its corners, gives fixed-point variance ratios of $1.003$ and $0.998$, analytically free of the residual. A closed-form bias analysis under a cubic phase mismatch shows the centered chirp-rate estimate is insensitive to first order. Monte Carlo experiments at $N=256$ (validated at $N=32$-$512$) measure frequency- and chirp-rate-axis efficiencies with median $1.03$ and worst case $1.07$ over $144$ cell positions at $-5$ dB. Threshold predictions hold within $1.0$ dB on four configurations not used in the calibration. The dechirp-FFT bank is fully parallel, and each of the four refinement iterations evaluates three DTFT samples per axis; under fixed operating conditions, per-estimate latency is constant at $O(N\log N)$ cost.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Miaomiao Wei, Jianjun Li, Yang Wang, Huaiyuan Chen, Lulu Gao, Hang Liu. 2026-08-17. Deterministic DTFT Interpolation for Joint Frequency and Chirp-Rate Estimation: Cell-Uniform Efficiency and Threshold Analysis. https://arxiv.org/abs/2608.01756

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Multi-Carrier Rydberg Atomic Quantum Receivers with Enhanced Bandwidth Feature for Communication and Sensing

Rydberg atomic quantum receivers (RAQRs) have attracted significant attention in recent years due to their ultra-high sensitivity. Although capable of precisely detecting the amplitude and phase of weak signals, conventional RAQRs face inherent limitations in accurately receiving wideband RF signals, due to the discrete nature of atomic energy levels and their intrinsic instantaneous bandwidth constraints. These limitations hinder their direct application to multi-carrier communication and sensing. To address this issue, this paper proposes a multi-carrier Rydberg atomic quantum receiver (MC-RAQR) structure with five energy levels. We derive the amplitude and phase of the MC-RAQR and extract the baseband electrical signal for signal processing. In terms of multi-carrier communication and sensing, we analyze the channel capacity and accuracy of angle of arrival (AoA) and distance parameters, respectively. Numerical results validate our proposed model, showing that the MC-RAQR can achieve up to a bandwidth of 11.7 MHz, which is 17-fold larger than the conventional RAQRs. As a result, the channel capacity and the resolution for multi-target sensing are improved significantly. Specifically, the channel capacity of MC-RAQR is 110-fold and 2.8-fold larger than the classical RF receivers and RAQRs, respectively. For sensing performance, the RMSE of AoA estimation for MC-RAQR exhibits 7.6-fold reduction, compared with the conventional RAQRs. Furthermore, the RMSE of distance estimation is $634$-fold smaller than that of the root-CRB of classical RF receivers, showing the superior performance of the MC-RAQR. This demonstrates its compatibility with waveforms such as orthogonal frequency-division multiplexing (OFDM) and its significant advantages for multi-carrier signal reception.

eess.SP

Channel Estimation in MIMO Systems Aided by Microwave Linear Analog Computers (MiLACs)

Microwave linear analog computers (MiLACs) have recently emerged as a promising solution for future gigantic multiple-input multiple-output (MIMO) systems, enabling beamforming with greatly reduced hardware and computational cost. However, channel estimation for MiLAC-aided systems remains an open problem. Conventional least squares (LS) and minimum mean square error (MMSE) estimation rely on intensive digital computation, which undermines the computational advantage offered by MiLACs. In this letter, we propose efficient LS and MMSE channel estimation schemes for MiLAC-aided MIMO systems. By designing the training precoder and combiner implemented by lossless and reciprocal MiLACs, the proposed schemes perform LS and MMSE estimation in the analog domain, leaving only simple digital scaling. They achieve identical estimation performance to their digital counterparts while significantly reducing computational complexity. Numerical results verify the effectiveness of the proposed schemes.

eess.SP

Joint Subcarrier Phase Recovery for Nonlinearity Mitigation

We propose a low-complexity phase recovery scheme that simultaneously mitigates laser phase noise and fiber nonlinearity across several subcarriers. In a long single-span link with Raman amplification, the scheme achieves 0.9 dB gain with 99 real multiplications per complex symbol.

eess.SP