Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 2608.14928

Impacts of Sulfate Injection Geoengineering on Particulate Matter with Diameter less than 2.5 μm

Lili Xia·Alan Robock·Simone Tilmes
View original source ↗Read source document ↗Export metadata ↓

Abstract

Particulate matter with aerodynamic diameter less than 2.5 μm (PM2.5) is of great concern for human health. Here, for the first time, we examine the impact of sulfate aerosol geoengineering on PM2.5, using the output from the Geoengineering Large Ensemble (GLENS) project. GLENS is an ensemble of climate model simulations injecting SO2 into the stratosphere to balance RCP8.5 forcing using the Community Earth System Model, version 1. GLENS geoengineering reduces global averaged surface PM2.5 mass concentrations compared with RCP8.5 and also changes PM2.5 composition with more percentages of organic carbon and sulfate. The total reduction of PM2.5 is a result of less dust and sea salt concentrations. Dust emission is declined under GLENS geoengineering because of increased soil moisture and leaf area index over desert regions, and less emission of sea salt is due to slower wind speeds when geoengineering is applied. Excluding dust and sea salt, there is more global averaged PM2.5 under GLENS geoengineering relative to RCP8.5, predominantly due to more aerosol phase secondary organic aerosol (SOA). Since gas precursors of SOA are prescribed in the simulations, a cooler environment with geoengineering tends to transfer more gas phase SOA to aerosol phase. Changes in PM2.5 concentration and composition with applied geoengineering may have potential human health impact. Another new finding of this study is that the large amount of injected SO2 does not increase surface sulfate aerosol as a component of PM2.5, as the majority of sulfate aerosol reaching the boundary layer is in the coarse mode, which represents a very small fraction of the PM2.5. But the difference of deposition spatial distribution between geoengineering and RCP8.5 may have potential impacts on ecosystem.

Explore related subjects

physics.ao-ph

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Lili Xia, Alan Robock, Simone Tilmes. 2026-08-14. Impacts of Sulfate Injection Geoengineering on Particulate Matter with Diameter less than 2.5 μm. https://arxiv.org/abs/2608.14928

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Surface Stokes drift from compact drifting wave buoys

Surface Stokes drift depends strongly on the energy and directions of short waves, which are incompletely resolved by routine wave observations. We derive surface Stokes drift vectors from wave measurements collected by compact drifting buoys during three deployments in the North-East Atlantic and the Alboran Sea. The calculation uses vertical-acceleration spectra and first directional Fourier moments, which describe the mean wave direction and directional concentration at each frequency; it accounts for the Doppler shift caused by buoy motion relative to the water and adds a calibrated high-frequency tail above an intrinsic frequency of 0.7 Hz. Across 13,139 records, the median estimated speed is 0.081 m/s at a median wind speed of 6.8 m/s. Over the measured band of 0.04-1 Hz, accounting for wave directions reduces the magnitude by a median 39% relative to the unidirectional assumption. The median ratio of the parameterised tail magnitude above 0.7 Hz to the total estimated magnitude is 0.37. Comparisons with WAVEWATCH III and Copernicus Marine MFWAM show strong covariation and similar wind-dependent differences from the buoy-derived estimates. On the station-matched sample from the two Atlantic deployments, WAVEWATCH III directional spectra indicate that these differences within the compared band arise mainly from spectral levels rather than from net directional reduction. The observations provide constraints for model evaluation; the contribution of the unresolved short waves remains sensitive to the assumed spectral tail and its directional spreading.

physics.ao-ph↗
arXiv2026

Unreported large errors from two PAMGuard three-dimensional localizers of whale calls

Confidence intervals of location (CIL) of calling marine mammals, derived from time-differences-of-arrival (TDOA) between receivers, depend on errors of TDOAs, receiver location, clocks, sound speeds, and location method. When these errors are minuscule, simulations yield small errors of PAMGuard's 3D simplex localizer when click sounds of beaked and sperm whales originate in a 1000 x 1000 x 1000 $\mbox{m}^3$ region using five receivers having horizontal and vertical separations of 1000 m and 150 m respectively. Realistic uncertainties of sound speed up to $\pm 10$ m/s lead to errors up to $10^{14}$ m. With clocks maintained by atomic standards and common practice of correcting TDOA from synchronization measurements at the start and end of an experiment, errors of location are up to $10^{4}$ m. Errors up to $10^2$ and $10^3$ m are found when the receiver's locations are uncertain within 10 and 40 m respectively. Errors of PAMGuard's 3D hyperbolic localizer are almost independent of the above uncertainties, yielding errors of location up to about $10^4$ m even when simulated errors are minuscule. Causes of PAMGuard's 3D location errors are unknown. These algorithms are briefly compared to another method designed to yield a reliable CIL.

physics.ao-ph↗
arXiv2026

Tropospheric Ozone Formation Potential and Related Design Considerations for Radiative Coolers

Recently, radiative coolers have been widely explored for reducing cooling loads or lowering temperatures in buildings, and at urban scales as a heat-mitigation measure. However, the potential impacts of radiative cooler deployment on the chemical composition of the atmosphere remain largely unexplored. A defining feature of recently-designed radiative coolers is their high ultraviolet (UV) reflectance, which is required for sub-ambient cooling under strong sunlight. Yet, wide adoption of such UV-reflective radiative coolers could substantially increase the UV actinic flux in the atmosphere above. This, in turn, may affect tropospheric ozone concentrations, particularly in urban atmospheres with high NOx concentrations. Here, as a case study, we use a 0-dimensional photochemical box model, constrained by field measurements of meteorological conditions and chemical concentrations in the urban environment of Houston, Texas, to explore the potential impact of the widespread use of UV-reflective radiative coolers on ozone concentrations. Our calculations show that complete deployment of radiative coolers may increase tropospheric ozone levels by as much as 30% during specific meteorological conditions in Houston. Informed by the wavelength-dependent modelling results, we propose specific designs, namely pigmented radiative coolers with different UV reflectances, and UV-absorptive visible-reemitting fluorescent radiative coolers, that could minimize negative ozone formation while retaining appreciable cooling performance. Our results motivate further study on the effects of widespread deployment of radiative cooling designs like superwhite roof paints on air quality, and materials that simultaneously minimize adverse photochemical impact and maximize cooling performance.

physics.ao-ph↗