Search arXivSearch

arXiv · physics/0012022

Direct measurement of sub-pixel structure of the EPIC MOS CCD on-board th e XMM/NEWTON satellite

Abstract

We have used a mesh experiment in order to measure the sub-pixel structure of the EPIC MOS CCDs on-board the XMM/NEWTON satellite. The EPIC MOS CCDs have 40 $μ$m-square pixels which have an open electrode structure in order to improve the detection efficiency for low-energy X-rays. We obtained restored pixel images for various X-ray event grades (e.g. split-pixel events, single pixel events, etc.) at various X-ray energies. We confirmed that the open electrode structure results in a distorted horizontal pixel boundary. The open electrode region generates both single pixel events and vertically split events, but no horizontally split events. Because the single pixel events usually show the best energy resolution, we discuss a method of increasing the fraction of single pixel events from the open electrode region. Furthermore, we have directly measured the thickness of the electrodes and dead-layers by comparing spectra from the open electrode region with those from the other regions: electrodes, electrode finger and channel stop. We can say that EPIC MOS CCDs are more radiation hard than front-illumination chips of ACIS on-board Chandra X-ray Observatory because of their extra absorption thickness above the charge transfer channel. We calcurated the mean pixel response and found that our estimation has a good agreement with that of the ground calibration of EPIC MOS CCD.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

J. Hiraga, H. Tsunemi, A. D. Short, A. F. Abbey, P. J. Bennie, M. J. L. Turner. 2000-12-12. Direct measurement of sub-pixel structure of the EPIC MOS CCD on-board th e XMM/NEWTON satellite. https://doi.org/10.1016/s0168-9002(01)00201-7

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

True Alternating Current Scanning Tunneling Microscope (ACSTM): tunneling on insulators

Scanning Tunneling Microscopy (STM) has revolutionized our atomic scale understanding of surfaces and accelerated progress in nanotechnology. This technique, however, is restricted to metal or semiconducting samples, as it requires a tiny current to stabilize the tip-sample distance with atomic scale precision. We developed a new imaging and feedback method that relies on true alternating current (AC) without any direct current (DC) component. This technique does not only enable the imaging on non-conducting surfaces with atomic step resolution, like (thin) glass and oxides, it provides also access to high-frequency electronic signal coming from the sample. We demonstrate that it is possible to measure on 25nm thick silicon oxide with 10 MHz tunneling current.

physics.ins-det

Charged-particle topology reconstruction with an in-liquid SiPM array

Liquid scintillator detectors instrumented with photosensors inside the scintillation volume preserve local optical information that is largely lost in conventional boundary-readout geometries. We demonstrate that this information is sufficient for charged-particle topology reconstruction using a sparse three-dimensional lattice of silicon photomultipliers. After validating the Geant4 detector response against measured photon-count distributions, a simulation-trained, time-informed convolutional neural network reconstructs the entry and exit points of through-going muons with median residuals of 1.91~cm and 2.39~cm, respectively. The reconstructed endpoints are geometrically consistent with acceptance regions defined by external trigger counters in cosmic-ray muon data. The same framework also reconstructs the production vertices of simulated positron starting-track events with a median residual of about 4.5~cm. These results establish the feasibility of topology-sensitive reconstruction using sparse in-liquid photosensor arrays in homogeneous liquid scintillator detectors.

physics.ins-det

Characterization of immersed SiPM arrays in liquid scintillator between room temperature and $-30\,^{\circ}\mathrm{C}$

Liquid scintillator detectors instrumented with distributed silicon photomultiplier (SiPM) arrays can be used in compact, topology-sensitive, and low-background experiments, but the temperature dependence of SiPMs immersed directly in the scintillation medium has not been widely characterized. We report the operation of a 125-liter linear-alkylbenzene-based liquid scintillator detector read out by 125 SiPM channels immersed in the active volume, over the range from room temperature to $-30\,^{\circ}\mathrm{C}$. The detector response was measured with cosmic-ray muons, including stopping muons followed by their Michel-electron decay. Cooling from $+15\,^{\circ}\mathrm{C}$ to $-30\,^{\circ}\mathrm{C}$ reduced the SiPM dark-count rate by a factor of 13.5, increased the single-photoelectron response by 49.1%, and increased the cosmic-ray muon light yield by 16.7%. The improved photoelectron separation and baseline stability at low temperature enabled a selection of stopping-muon events, from which the effective muon lifetime was measured to be $1959\pm132\,\mathrm{ns}$, consistent with the value expected for a hydrocarbon scintillator once $μ^{-}$ capture on carbon is taken into account.

physics.ins-det