arXiv subjects

Al Jaber Mahmud

Publications and source records attributed to Al Jaber Mahmud.

4 recordsLinked to original sources

arXiv2026

Contact as a Decision Variable: Capability-Tradeoff Contact Selection for Legged Loco-Manipulation

In this paper, we study the joint selection of an environmental support contact and a whole-body configuration for a prescribed loco-manipulation task. A contact may provide greater physical support while restricting the motion required for the task. We formulate this problem through three capability measures: residual wrench, end-effector reach, and base mobility available after satisfying the task requirements, and we balance them against contact acquisition cost. Evaluating these capabilities for every candidate requires repeated whole-body optimizations. To reduce this computational cost, we propose Capability-Tradeoff Contact Selection (CTCS). CTCS screens candidates for contact and task feasibility, groups similar candidates within each surface, and predicts their capabilities from exact anchor evaluations using local sensitivity analysis. It checks these predictions through selective exact evaluations, ranks candidates by capability, and evaluates a shortlist exactly for final selection. We evaluate CTCS in simulations and hardware experiments using a Unitree Go2 quadruped with an AgileX NERO arm across $392$ task conditions with nine available support surfaces. Results show that CTCS outperforms ground-only and fixed-contact support, as it can select support surfaces that provide favorable capability trade-offs for the task. Compared with evaluating every candidate exactly, CTCS achieves approximately $3\times$ speedup while closely matching the resulting mean objective value.

cs.RO↗

arXiv2026

Mutual Adaptation in Human-Robot Co-Transportation with Human Preference Uncertainty

Mutual adaptation can enhance overall task performance in human-robot co-transportation by integrating both the robot's and the human's understanding of the environment. While human modeling helps capture humans' subjective preferences, two challenges persist: (i) the uncertainty of human preference parameters and (ii) the need to balance adaptation strategies that benefit both humans and robots. In this paper, we propose a unified framework to address these challenges and improve task performance through mutual adaptation. First, instead of relying on fixed parameters, we model a probability distribution of human choices by incorporating a range of uncertain human preference parameters. Building on this, we introduce a time-varying stubbornness measure and a coordinated planning model, which allows either the robot to lead the team's trajectory or, if a human's preferred path conflicts with the robot's plan and their stubbornness exceeds a threshold, the robot to transition to following the human. Finally, we introduce a pose optimization strategy for low-level control to mitigate the uncertain human behaviors when they are leading. To validate the framework, we design and perform a study with human feedback from twenty human participants. We then demonstrate, through simulations, the effectiveness of our models in enhancing task performance with mutual adaptation and pose optimization.

cs.RO↗

arXiv2026

Geometry-Aligned LLM Fine-Tuning for Sequential Narrow-Opening Planning

We study rigid-body motion planning through multiple sequential narrow openings, which requires long-horizon geometric reasoning because the configuration used to traverse an early opening constrains the set of reachable configurations for subsequent ones. To achieve this, we propose a geometry-aligned large language model (LLM) fine-tuning framework that generates fixed-length, machine-readable waypoint sequences that are both geometrically feasible and coordinated across openings. Our approach uses a bi-level training pipeline. First, we perform failure-driven LoRA supervised fine-tuning (SFT) on human demonstrations, which incorporates structured failure feedback to teach the model common failure modes and enforce the output format. Second, we refine the same LoRA adapters using Group Relative Policy Optimization (GRPO) with geometric verification: each sampled waypoint sequence is densified by a model-based planner and scored with a deterministic geometry-derived reward to achieve continuous-motion feasibility. To validate the effectiveness of our proposed method, we provide both quantitative and qualitative results from simulations. Our method achieves the highest success rate in both in-distribution and out-of-distribution environments and qualitatively exhibits long-horizon geometric reasoning by selecting exit poses that facilitate entry into subsequent openings.

cs.RO↗

arXiv2025

Human-Robot Co-Transportation using Disturbance-Aware MPC with Pose Optimization

This paper proposes a new control algorithm for human-robot co-transportation using a robot manipulator equipped with a mobile base and a robotic arm. We integrate the regular Model Predictive Control (MPC) with a novel pose optimization mechanism to more efficiently mitigate disturbances (such as human behavioral uncertainties or robot actuation noise) during the task. The core of our methodology involves a two-step iterative design: At each planning horizon, we determine the optimal pose of the robotic arm (joint angle configuration) from a candidate set, aiming to achieve the lowest estimated control cost. This selection is based on solving a disturbance-aware Discrete Algebraic Ricatti Equation (DARE), which also determines the optimal inputs for the robot's whole body control (including both the mobile base and the robotic arm). To validate the effectiveness of the proposed approach, we provide theoretical derivation for the disturbance-aware DARE and perform simulated experiments and hardware demos using a Fetch robot under varying conditions, including different trajectories and different levels of disturbances. The results reveal that our proposed approach outperforms baseline algorithms.

cs.RO↗