arXiv subjects

Chunhua Tian

Publications and source records attributed to Chunhua Tian.

3 recordsLinked to original sources

arXiv2026

Defect-controlled twin activation in crystallographically equivalent magnesium micropillars

Tensile twinning plays a central role in accommodating -axis plasticity in Mg. In bulk Mg, it typically shows a relatively deterministic response with a low critical stress, whereas in confined volumes it exhibits broad yield-stress distributions that complicate the prediction of small-scale mechanical behavior. Here, site-specific compression tests are performed on 4 $μ$m-diameter pillars fabricated in a parent Mg crystal and an adjacent {10-12} twin. The two regions share the same [11-20] compression axis but experienced different prior deformation histories, allowing the influence of the residual microstructural state to be examined at fixed crystallographic orientation. Among 27 pillars, most parent-region pillars yield near 300 MPa, whereas pillars from the twin region span approximately 30 to 300 MPa. Interrupted tests combined with cross-sectional EBSD link individual load drops to discrete twin formation and further show that a pillar containing a pre-existing twin yields at approximately 80 MPa through the migration of the existing twin boundary. Molecular dynamics simulations of 30 nm-diameter pillars resolve possible atomistic pathways at the nanoscale. The simulations illustrate how contact geometry and pre-existing twin embryos alter event selection, and how an activated twin advances rapidly, while coherent twin boundary migration proceeds through disconnection motion accompanied by crystallographically required atomic shuffles. The results attribute the experimental scatter to the local availability of embryos and mobile interfaces, such that the first plastic event is governed by the twinning pathway accessible from the local microstructural state rather than by a single characteristic critical stress. Deformation history can therefore strongly modify the distribution of first plastic events even when the loading orientation is fixed.

cond-mat.mtrl-sci↗

arXiv2024

Fracture of the $C$15 CaAl$_2$ Laves phase at small length-scales

The cubic $C$15 CaAl$_2$ Laves phase is a crucial brittle intermetallic precipitate in Mg-Al-Ca alloys. Although knowledge of the mechanical properties of coexisting phases is essential for improved alloy design, the fracture toughness is not yet studied experimentally due to the need for miniaturised testing. Here, micropillar splitting and microcantilever bending are used to experimentally determine the toughness of CaAl$_2$. It is found that the toughness value of ~1 $MPa\cdot\sqrt m$ from pillar splitting is largely insensitive to sample heat treatment, ion beam used for fabrication, micropillar diameter, and surface orientation. From nanoindentation supported by electron channelling contrast imaging and backscatter diffraction, fracture is observed to take place mostly on {011} planes. Atomistic fracture simulations on a model $C$15 Laves phase showed that the preference of {011} cleavage planes over the more energetically favourable {111} is due to lattice trapping and kinetics controlling fracture. Using rectangular microcantilever bending tests where the notch plane was misoriented to the closest possible {112} cleavage plane by ~8°, and the closest {001}, {011} and {111} plane by >20°, a toughness of ca. 2 $MPa\cdot\sqrt m$ was determined along with the electron microscopy observation of significant deviations of the crack path, demonstrating that preferential crystallographic cleavage planes determine the toughness in this material. Further investigation using pentagonal microcantilevers with precise alignment of the notch with the cleavage planes revealed similar fracture toughness values for different low-index planes. The results presented here are the first detailed experimental study of fracture toughness of the $C$15 CaAl$_2$ Laves phase, and can be understood in terms of crack plane and crack front dependent fracture toughness.

cond-mat.mtrl-sci↗

arXiv2022

Preferred corrosion pathways for oxygen in Al2Ca-twin boundaries and dislocations

With an ongoing discussion on the oxygen diffusion along crystal defects remaining, it is difficult to study this phenomenon in Al containing intermetallic materials due to its rapid and passivating oxide formation. We report here the observation of enhanced oxygen diffusion along crystal defects, i.e. dislocations and twin boundaries, in the C15 Al 2 Ca Laves phase and how the presence of oxygen induces structural changes at these defects. Three main phases were identified and characterized structurally by aberration-corrected, atomic resolution scanning transmission electron microscopy, analytically by energy dispersive X-ray spectroscopy and electron energy loss spectroscopy. Unlike the C15 bulk phase, the twin boundary and dislocation transformed into a few nanometer wide amorphous phase, which depletes in Al and Ca but is highly enriched in oxygen. The dislocation even shows coexistence of the amorphous phase with a simple Al-rich A1 fcc phase. This A1 phase only depletes in Ca, not in Al (Al remains at bulk concentration), and is also enriched in oxygen. The Al-rich A1 phase is coherent with the C15 matrix. Electron energy loss spectroscopy revealed the amorphous phase to be Al 2 O 3 . We thereby show as one of the first studies that oxygen diffusion along crystal defects, especially also at the twin boundary can induce the formation of an amorphous oxide along themselves. The identification of oxygen-induced transformation at strained defects has to be considered when the material is exposed to air during plastic deformation at elevated temperatures.

cond-mat.mtrl-sci↗