arXiv subjects

David Reilly

Publications and source records attributed to David Reilly.

3 recordsLinked to original sources

arXiv2026

Optimal operating temperature for industry-compatible silicon spin quantum computing: colder is not necessarily better

Silicon spin qubits are a leading candidate for large-scale quantum computing owing to their compatibility with semiconductor manufacturing. However, scaling to useful fault-tolerant processors will likely generate thermal loads that exceed the cooling power available at millikelvin temperatures. Raising the operating temperature eases cooling requirements but reduces gate fidelity, increasing the overhead of quantum error correction. Identifying the operating temperature that minimizes total power consumption is therefore a key challenge for commercially viable quantum computers. Here, we use gate set tomography to benchmark two-qubit silicon chips fabricated in both industrial and academic environments over a range of temperatures. Elevated temperatures substantially shorten coherence times and increase gate and state-preparation-and-measurement infidelities. Based on these measurements, we develop a general power model for silicon quantum computers that combines cryogenic cooling requirements with error-correction overheads. We show that a finite optimal operating temperature exists and is strongly influenced by a crossover temperature near 1 K in current devices, above which gate fidelity degrades rapidly. These results connect device-level fidelity limitations to system-level power requirements, providing design guidelines for large-scale silicon quantum computers.

quant-ph↗

arXiv2022

InAs-Al Hybrid Devices Passing the Topological Gap Protocol

We present measurements and simulations of semiconductor-superconductor heterostructure devices that are consistent with the observation of topological superconductivity and Majorana zero modes. The devices are fabricated from high-mobility two-dimensional electron gases in which quasi-one-dimensional wires are defined by electrostatic gates. These devices enable measurements of local and non-local transport properties and have been optimized via extensive simulations to ensure robustness against non-uniformity and disorder. Our main result is that several devices, fabricated according to the design's engineering specifications, have passed the topological gap protocol defined in Pikulin et al. [arXiv:2103.12217]. This protocol is a stringent test composed of a sequence of three-terminal local and non-local transport measurements performed while varying the magnetic field, semiconductor electron density, and junction transparencies. Passing the protocol indicates a high probability of detection of a topological phase hosting Majorana zero modes as determined by large-scale disorder simulations. Our experimental results are consistent with a quantum phase transition into a topological superconducting phase that extends over several hundred millitesla in magnetic field and several millivolts in gate voltage, corresponding to approximately one hundred micro-electron-volts in Zeeman energy and chemical potential in the semiconducting wire. These regions feature a closing and re-opening of the bulk gap, with simultaneous zero-bias conductance peaks at both ends of the devices that withstand changes in the junction transparencies. The extracted maximum topological gaps in our devices are 20-60 $\mu$eV. This demonstration is a prerequisite for experiments involving fusion and braiding of Majorana zero modes.

cond-mat.mes-hall↗

arXiv2022

Probing quantum devices with radio-frequency reflectometry

Many important phenomena in quantum devices are dynamic, meaning that they cannot be studied using time-averaged measurements alone. Experiments that measure such transient effects are collectively known as fast readout. One of the most useful techniques in fast electrical readout is radio-frequency reflectometry, which can measure changes in impedance (both resistive and reactive) even when their duration is extremely short, down to a microsecond or less. Examples of reflectometry experiments, some of which have been realised and others so far only proposed, include projective measurements of qubits and Majorana devices for quantum computing, real-time measurements of mechanical motion and detection of non-equilibrium temperature fluctuations. However, all of these experiments must overcome the central challenge of fast readout: the large mismatch between the typical impedance of quantum devices (set by the resistance quantum) and of transmission lines (set by the impedance of free space). Here, we review the physical principles of radio-frequency reflectometry and its close cousins, measurements of radio-frequency transmission and emission. We explain how to optimise the speed and sensitivity of a radio-frequency measurement, and how to incorporate new tools such as superconducting circuit elements and quantum-limited amplifiers into advanced radio-frequency experiments. Our aim is three-fold: to introduce the readers to the technique, to review the advances to date and to motivate new experiments in fast quantum device dynamics. Our intended audience includes experimentalists in the field of quantum electronics who want to implement radio-frequency experiments or improve them, together with physicists in related fields who want to understand how the most important radio-frequency measurements work.

cond-mat.mes-hall↗