arXiv subjects

Emilia Zięba-Ostój

Publications and source records attributed to Emilia Zięba-Ostój.

4 recordsLinked to original sources

arXiv2026

Broadband emitter localization and prefabrication two-photon interference from InAs/InP quantum dots monolithically grown on an InGaAsP/InP distributed Bragg reflector

We demonstrate a monolithic telecom C-band single-photon platform based on low-density InAs/InP quantum dots grown on an InGaAsP/InP distributed Bragg reflector, with simulated upward light-extraction efficiency exceeding 10% within the 40 nm spectral band. Enhanced light extraction is crucial for wide-field photoluminescence imaging, enabling approximately 3 nm statistical centroid-localization precision of QD emitters due to improved signal-to-noise ratio. The identified charged exciton emitting at 1549.5 nm exhibits single-photon emission purity up to 94.7%, validated by a raw peak-area integration under pulsed quasi-resonant excitation. Under these conditions, photons emitted sequentially from the unprocessed planar structure reveal a raw two-photon interference visibility of 51% of the photon wave packet within the 2 ns time window and 41% over a 4 ns integration window, all without Purcell enhancement typical for cavity-embedded emitters. Combining broadband extraction, high photon coherence, and emitter preselection on a native III-V wafer, this architecture paves the way for marker-based deterministic fabrication of high-quality monolithic nanophotonic devices.

cond-mat.mes-hall↗

arXiv2025

Efficient passivation of III-As(P) photonic interfaces

Surface effects can significantly impact the performance of nanophotonic and quantum photonic devices, especially as the device dimensions are reduced. In this work, we propose and investigate a novel approach to surface passivation to mitigate these challenges in photonic nanostructures with III-As(P) quantum wells defined by a dry etching process. The nanostructures are annealed under the phosphine (PH$_3$) ambient inside a metal-organic vapor phase epitaxy chamber to eliminate surface and subsurface defects induced during the dry etching and subsequent oxidation of the etched sidewalls. Moreover, encapsulation of the active material with a wider bandgap material allows for maintaining the band structure of the device, mitigating band bending effects. Our findings reveal an almost order of magnitude reduction in the surface recombination velocity from $2 \times 10^3 \, \mathrm{cm/s}$ for the PH$_3$ annealing compared to $1.5 \times 10^4 \, \mathrm{cm/s}$ for the non-passivated structures and $5 \times 10^3 \, \mathrm{cm/s}$ for the standard method based on (NH$_4$)$_2$S wet treatment followed by Al$_2$O$_3$ encapsulation. A further reduction to $5 \times 10^2 \, \mathrm{cm/s}$ is achieved for the InP-regrown samples. Additionally, we develop a model accounting for the impact of surface charges in the analysis of time-resolved photoluminescence curves and demonstrate that the proposed passivation method effectively reduces the surface charge density on the sidewalls of the studied quantum well-based photonic nanostructures.

physics.optics↗

arXiv2024

High-throughput quantum photonic devices emitting indistinguishable photons in the telecom C-band

Single indistinguishable photons at telecom C-band wavelengths are essential for quantum networks and the future quantum internet. However, high-throughput technology for single-photon generation at 1550 nm remained a missing building block to overcome present limitations in quantum communication and information technologies. Here, we demonstrate the high-throughput fabrication of quantum-photonic integrated devices operating at C-band wavelengths based on epitaxial semiconductor quantum dots. Our technique enables the deterministic integration of single pre-selected quantum emitters into microcavities based on circular Bragg gratings. Respective devices feature the triggered generation of single photons with ultra-high purity and record-high photon indistinguishability. Further improvements in yield and coherence properties will pave the way for implementing single-photon non-linear devices and advanced quantum networks at telecom wavelengths.

quant-ph↗

arXiv2024

On-Demand Generation of Indistinguishable Photons in the Telecom C-Band using Quantum Dot Devices

Semiconductor quantum dots (QDs) enable the generation of single and entangled photons, useful for various applications in photonic quantum technologies. Specifically for quantum communication via fiber-optical networks, operation in the telecom C-band centered around 1550$\,$nm is ideal. The direct generation of QD-photons in this spectral range and with high quantum-optical quality, however, remained challenging. Here, we demonstrate the coherent on-demand generation of indistinguishable photons in the telecom C-band from single QD devices consisting of InAs/InP QD-mesa structures heterogeneously integrated with a metallic reflector on a silicon wafer. Using pulsed two-photon resonant excitation of the biexciton-exciton radiative cascade, we observe Rabi rotations up to pulse areas of $4π$ and a high single-photon purity in terms of $g^{(2)}(0)=0.005(1)$ and $0.015(1)$ for exciton and biexciton photons, respectively. Applying two independent experimental methods, based on fitting Rabi rotations in the emission intensity and performing photon cross-correlation measurements, we consistently obtain preparation fidelities at the $π$-pulse exceeding 80$\%$. Finally, performing Hong-Ou-Mandel-type two-photon interference experiments we obtain a photon-indistinguishability of the full photon wave packet of up to $35(3)\%$, representing a significant advancement in the photon-indistinguishability of single photons emitted directly in the telecom C-band.

quant-ph↗