arXiv subjects

Jan Goetz

Publications and source records attributed to Jan Goetz.

14 recordsLinked to original sources

arXiv2021

A low-noise on-chip coherent microwave source

The scaleup of quantum computers operating in the microwave domain requires advanced control electronics, and the use of integrated components that operate at the temperature of the quantum devices is potentially beneficial. However, such an approach requires ultra-low power dissipation and high signal quality in order to ensure quantum-coherent operations. Here, we report an on-chip device that is based on a Josephson junction coupled to a spiral resonator and is capable of coherent continuous-wave microwave emission. We show that characteristics of the device accurately follow a theory based on a perturbative treatment of the capacitively shunted Josephson junction as a gain element. The infidelity of typical quantum gate operations due to the phase noise of this cryogenic 25-pW microwave source is less than 0.1% up to 10-ms evolution times, which is below the infidelity caused by dephasing in state-of-the-art superconducting qubits. Together with future cryogenic amplitude and phase modulation techniques, our approach may lead to scalable cryogenic control systems for quantum processors.

quant-ph↗

arXiv2020

In-situ tunable nonlinearity and competing signal paths in coupled superconducting resonators

We have fabricated and studied a system of two tunable and coupled nonlinear superconducting resonators. The nonlinearity is introduced by galvanically coupled dc-SQUIDs. We simulate the system response by means of a circuit model, which includes an additional signal path introduced by the electromagnetic environment. Furthermore, we present two methods allowing us to experimentally determine the nonlinearity. First, we fit the measured frequency and flux dependence of the transmission data to simulations based on the equivalent circuit model. Second, we fit the power dependence of the transmission data to a model that is predicted by the nonlinear equation of motion describing the system. Our results show that we are able to tune the nonlinearity of the resonators by almost two orders of magnitude via an external coil and two on-chip antennas. The studied system represents the basic building block for larger systems, allowing for quantum simulations of bosonic many-body systems with a larger number of lattice sites.

cond-mat.supr-con↗

arXiv2020

Photon-number-dependent effective Lamb shift

The Lamb shift, an energy shift arising from the presence of the electromagnetic vacuum, has been observed in various quantum systems and established as the part of the energy shift independent of the environmental photon number. However, typical studies are based on simplistic bosonic models which may be challenged in practical quantum devices. We demonstrate a hybrid bosonic-fermionic environment for a linear resonator mode and observe that the photon number in the environment can dramatically increase both the dissipation and the effective Lamb shift of the mode. Our observations are quantitatively described by a first-principles model which we develop here also to guide device design for future quantum-technological applications. The device demonstrated here can be utilized as a fully rf-operated quantum-circuit refrigerator to quickly reset superconducting qubits.

quant-ph↗

arXiv2020

Tunable refrigerator for non-linear quantum electric circuits

The emerging quantum technological applications call for fast and accurate initialization of the corresponding devices to low-entropy quantum states. To this end, we theoretically study a recently demonstrated quantum-circuit refrigerator in the case of non-linear quantum electric circuits such as superconducting qubits. The maximum refrigeration rate of transmon and flux qubits is observed to be roughly an order of magnitude higher than that of usual linear resonators, increasing flexibility in the design. We find that for typical experimental parameters, the refrigerator is suitable for resetting different qubit types to fidelities above 99.99% in a few or a few tens of nanoseconds depending on the scenario. Thus the refrigerator appears to be a promising tool for quantum technology and for detailed studies of open quantum systems.

cond-mat.mes-hall↗

arXiv2019

Fast control of dissipation in a superconducting resonator

We report on fast tunability of an electromagnetic environment coupled to a superconducting coplanar waveguide resonator. Namely, we utilize a recently-developed quantum-circuit refrigerator (QCR) to experimentally demonstrate a dynamic tunability in the total damping rate of the resonator up to almost two orders of magnitude. Based on the theory it corresponds to a change in the internal damping rate by nearly four orders of magnitude. The control of the QCR is fully electrical, with the shortest implemented operation times in the range of 10 ns. This experiment constitutes a fast active reset of a superconducting quantum circuit. In the future, a similar scheme can potentially be used to initialize superconducting quantum bits.

quant-ph↗

arXiv2019

Calibration of cryogenic amplification chains using normal-metal--insulator--superconductor junctions

Various applications of quantum devices call for an accurate calibration of cryogenic amplification chains. To this end, we present a convenient calibration scheme and use it to accurately measure the total gain and noise temperature of an amplification chain by employing normal-metal--insulator--superconductor (NIS) junctions. Our method is based on the radiation emitted by inelastic electron tunneling across voltage-biased NIS junctions. We derive an analytical equation that relates the generated power to the applied bias voltage which is the only control parameter of the device. After the setup has been characterized using a standard voltage reflection measurement, the total gain and the noise temperature are extracted by fitting the analytical equation to the microwave power measured at the output of the amplification chain. The 1$\sigma$ uncertainty of the total gain of 51.84 dB appears to be of the order of 0.1 dB.

quant-ph↗

arXiv2018

Optimized heat transfer at exceptional points in quantum circuits

Superconducting quantum circuits are potential candidates to realize a large-scale quantum computer. The envisioned large density of integrated components, however, requires a proper thermal management and control of dissipation. To this end, it is advantageous to utilize tunable dissipation channels and to exploit the optimized heat flow at exceptional points (EPs). Here, we experimentally realize an EP in a superconducting microwave circuit consisting of two resonators. The EP is a singularity point of the Hamiltonian, and corresponds to the most efficient heat transfer between the resonators without oscillation of energy. We observe a crossover from underdamped to overdamped coupling via the EP by utilizing photon-assisted tunneling as an \emph{in situ} tunable dissipative element in one of the resonators. The methods studied here can be applied to different circuits to obtain fast dissipation, for example, for initializing qubits to their ground states. In addition, these results pave the way towards thorough investigation of parity--time ($\mathcal{PT}$) symmetric systems and the spontaneous symmetry breaking in superconducting microwave circuits operating at the level of single energy quanta.

cond-mat.mes-hall↗

arXiv2018

Qubit Measurement by Multichannel Driving

We theoretically propose and experimentally implement a method of measuring a qubit by driving it close to the frequency of a dispersively coupled bosonic mode. The separation of the bosonic states corresponding to different qubit states begins essentially immediately at maximum rate, leading to a speedup in the measurement protocol. Also the bosonic mode can be simultaneously driven to optimize measurement speed and fidelity. We experimentally test this measurement protocol using a superconducting qubit coupled to a resonator mode. For a certain measurement time, we observe that the conventional dispersive readout yields close to 100% higher average measurement error than our protocol. Finally, we use an additional resonator drive to leave the resonator state to vacuum if the qubit is in the ground state during the measurement protocol. This suggests that the proposed measurement technique may become useful in unconditionally resetting the resonator to a vacuum state after the measurement pulse.

quant-ph↗

arXiv2018

Observation of a broadband Lamb shift in an engineered quantum system

The shift of energy levels owing to broadband electromagnetic vacuum fluctuations, the Lamb shift, has been pivotal in the development of quantum electrodynamics and in understanding atomic spectra. Currently, small energy shifts in engineered quantum systems are of paramount importance owing to the extreme precision requirements in applications such as quantum computing. However, without a tunable environment it is challenging to resolve the Lamb shift in its original broadband case. Consequently, the observations in other than atomic systems are limited to environments comprised of narrow-band modes. Here, we observe a broadband Lamb shift in high-quality superconducting resonators, a scenario also accessing static shifts inaccessible in Lamb's experiment. We measure a continuous change of several megahertz in the fundamental resonator frequency by externally tuning the coupling strength of the engineered broadband environment which is based on hybrid normal-metal--superconductor tunnel junctions. Our results may lead to improved control of dissipation in high-quality engineered quantum systems and open new possibilities for studying synthetic open quantum matter using this hybrid experimental platform.

cond-mat.mes-hall↗

arXiv2018

Compact 3D quantum memory

Superconducting 3D microwave cavities offer state-of-the-art coherence times and a well controlled environment for superconducting qubits. In order to realize at the same time fast readout and long-lived quantum information storage, one can couple the qubit both to a low-quality readout and a high-quality storage cavity. However, such systems are bulky compared to their less coherent 2D counterparts. A more compact and scalable approach is achieved by making use of the multimode structure of a 3D cavity. In our work, we investigate such a device where a transmon qubit is capacitively coupled to two modes of a single 3D cavity. The external coupling is engineered so that the memory mode has an about 100 times larger quality factor than the readout mode. Using an all-microwave second-order protocol, we realize a lifetime enhancement of the stored state over the qubit lifetime by a factor of $6$ with a fidelity of approximately $80\%$ determined via quantum process tomography. We also find that this enhancement is not limited by fundamental constraints.

quant-ph↗

arXiv2017

Parity-Engineered Light-Matter Interaction

The concept of parity describes the inversion symmetry of a system and is of fundamental relevance in the standard model, quantum information processing, and field theory. In quantum electrodynamics, parity is conserved and large field gradients are required to engineer the parity of the light-matter interaction operator. In this work, we engineer a potassium-like artificial atom represented by a specifically designed superconducting flux qubit. We control the wave function parity of the artificial atom with an effective orbital momentum provided by a resonator. By irradiating the artificial atom with spatially shaped microwave fields, we select the interaction parity in situ. In this way, we observe dipole and quadrupole selection rules for single state transitions and induce transparency via longitudinal coupling. Our work advances the design of tunable artificial multilevel atoms to a new level, which is particularly promising with respect to quantum chemistry simulations with near-term superconducting circuits.

quant-ph↗

arXiv2016

Flux-driven Josephson parametric amplifiers: Hysteretic flux response and nondegenerate gain measurements

Josephson parametric amplifiers (JPA) have become key devices in quantum science and technology with superconducting circuits. In particular, they can be utilized as quantum-limited amplifiers or as a source of squeezed microwave fields. Here, we report on the detailed measurements of five flux-driven JPAs, three of them exhibiting a hysteretic dependence of the resonant frequency versus the applied magnetic flux. We model the measured characteristics by numerical simulations based on the two-dimensional potential landscape of the dc superconducting quantum interference devices (dc-SQUID), which provide the JPA nonlinearity, for a finite screening parameter $\beta_\mathrm{L}\,{>}\,0$ and demonstrate excellent agreement between the numerical results and the experimental data. Furthermore, we study the nondegenerate response of different JPAs and accurately describe the experimental results with our theory.

cond-mat.supr-con↗

arXiv2015

Loss mechanisms in superconducting thin film microwave resonators

We present a systematic analysis of the internal losses of superconducting coplanar waveguide microwave resonators based on niobium thin films on silicon substrates. In particular, we investigate losses introduced by Nb/Al interfaces in the center conductor, which is important for experiments where Al based Josephson junctions are integrated into Nb based circuits. We find that these interfaces can be a strong source for two-level state (TLS) losses, when the interfaces are not positioned at current nodes of the resonator. In addition to TLS losses, for resonators including Al, quasiparticle losses become relevant above 200 mK. Finally, we investigate how losses generated by eddy currents in conductive material on the backside of the substrate can be minimized by using thick enough substrates or metals with high conductivity on the substrate backside.

cond-mat.supr-con↗

arXiv2015

Spin-boson model with an engineered reservoir in circuit quantum electrodynamics

A superconducting qubit coupled to an open transmission line represents an implementation of the spin-boson model with a broadband environment. We show that this environment can be engineered by introducing partial reflectors into the transmission line, allowing to shape the spectral function, J({\omega}), of the spin-boson model. The spectral function can be accessed by measuring the resonance fluorescence of the qubit, which provides information on both the engineered environment and the coupling between qubit and transmission line. The spectral function of a transmission line without partial reflectors is found to be Ohmic over a wide frequency range, whereas a peaked spectral density is found for the shaped environment. Our work lays the ground for future quantum simulations of other, more involved, impurity models with superconducting circuits.

cond-mat.mes-hall↗