Search arXivSearch

arXiv subjects

Sarra Bouchkati

Publications and source records attributed to Sarra Bouchkati.

5 recordsLinked to original sources

Safety Screening for Voltage Control in Active Distribution Grids via Distributionally Robust Conformal Screening

Deploying a new control policy for voltage control in active distribution grids requires evidence that physical limits will be satisfied before the policy is tested on the physical grid. This assessment is difficult for two reasons. First, simulations cannot capture every disturbance, modeling error, and device interaction present in the real grid. Second, historical measurements reflect operation under existing control policies, whereas a new policy may drive the grid into different operating conditions. To address these challenges, we propose Distributionally Robust Conformal Safety Screening (DR-CSS), a policy-agnostic framework for pre-deployment, scenario-by-scenario screening of a new control policy using historical data and a nominal simulator. For each new scenario, the simulator predicts a future voltage trajectory for the whole grid; DR-CSS then constructs a conformal safety interval around this prediction using historical simulation-to-reality errors. The interval is further enlarged to account for closed-loop changes induced by the deployment of the new policy and its interactions with the remaining controllers. To the best of our knowledge, DR-CSS is the first framework in power systems to combine historical data from an existing control policy with an imperfect simulator for pre-deployment safety screening of a new policy. Experiments on the IEEE 33-bus and IEEE 141-bus systems evaluate the deployment of learning-based voltage control policies and show that DR-CSS identifies all unsafe test scenarios. To reduce unnecessary warnings on safe scenarios, we adapt the safety intervals to different operating conditions and gradually introduce new policies with recalibration after each stage. These extensions increase the informational value of the safety screening and support safer deployment decisions in active distribution grids.

eess.SY

Physics-Informed Neural Network for Modeling the Dynamic Behavior of Grid-Forming Converters

This paper investigates physics-informed neural networks for modeling the full dynamic behavior of droop-controlled grid-forming converters. The approach is trained on synthetic data generated via numerical solvers and benchmarked against both traditional integration methods and a vanilla neural network. Results show higher predictive accuracy than the vanilla network using the same training data and substantially reduced runtime compared with numerical solvers.

eess.SY

Robustness of Reinforcement Learning-Based Congestion Management in Low-Voltage Grids

Increases in photovoltaic generation, charging of electric vehicles and heat-pump demand challenge operating limits in low-voltage distribution grids. This requires curative curtailment methods that can operate under sparse observability, noisy measurements, and imperfect grid models. Unlike prior end-to-end reinforcement-learning approaches for partially observable curtailment, this work decouples congestion detection and control by combining a random-forest violation pre-classifier with an actor-critic controller, and evaluates its robustness to measurement noise and grid-parameter mismatch. The framework is tested on a real low-voltage grid using synthetic future operating scenarios with low observability and controllability. With accurate grid parameters, the controller reduces total violation magnitude by 98.9%, and this performance remains nearly unchanged under the tested measurement-noise settings. Grid-model mismatch proves to be more challenging, but the controller still mitigates most violations under the tested mismatch assumptions.

eess.SY

Partially Observable Residual Reinforcement Learning for PV-Inverter-Based Voltage Control in Distribution Grids

This paper introduces an efficient Residual Reinforcement Learning (RRL) framework for voltage control in active distribution grids. Voltage control remains a critical challenge in distribution grids, where conventional Reinforcement Learning (RL) methods often suffer from slow training convergence and inefficient exploration. To overcome these challenges, the proposed RRL approach learns a residual policy on top of a modified Sequential Droop Control (SDC) mechanism, ensuring faster convergence. Additionally, the framework introduces a Local Shared Linear (LSL) architecture for the Q-network and a Transformer-Encoder actor network, which collectively enhance overall performance. Unlike several existing approaches, the proposed method relies solely on inverters' measurements without requiring full state information of the power grid, rendering it more practical for real-world deployment. Simulation results validate the effectiveness of the RRL framework in achieving rapid convergence, minimizing active power curtailment, and ensuring reliable voltage regulation.

eess.SY

End-to-End Reinforcement Learning of Curative Curtailment with Partial Measurement Availability

In the course of the energy transition, the expansion of generation and consumption will change, and many of these technologies, such as PV systems, electric cars and heat pumps, will influence the power flow, especially in the distribution grids. Scalable methods that can make decisions for each grid connection are needed to enable congestion-free grid operation in the distribution grids. This paper presents a novel end-to-end approach to resolving congestion in distribution grids with deep reinforcement learning. Our architecture learns to curtail power and set appropriate reactive power to determine a non-congested and, thus, feasible grid state. State-of-the-art methods such as the optimal power flow (OPF) demand high computational costs and detailed measurements of every bus in a grid. In contrast, the presented method enables decisions under sparse information with just some buses observable in the grid. Distribution grids are generally not yet fully digitized and observable, so this method can be used for decision-making on the majority of low-voltage grids. On a real low-voltage grid the approach resolves 100\% of violations in the voltage band and 98.8\% of asset overloads. The results show that decisions can also be made on real grids that guarantee sufficient quality for congestion-free grid operation.

cs.LG