Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 1705.00116

Wear-resistant thin films of MRI-230D-Mg alloy using plasma-driven electrolytic oxidation

G. Rapheal·S. Kumar·C. Blawert·Narendra B. Dahotre
View original source ↗Read source document ↗Export metadata ↓

Abstract

Wear resistant coatings were produced on a permanent mould cast MRI 230D Mg alloy by (a) PEO in silicate based electrolyte, (b) PEO in phosphate based electrolyte, (c) hybrid coatings of silicate PEO followed by laser surface alloying (LSA) with Al and Al2O3, and (d) hybrid coatings of phosphate PEO followed by LSA with Al and Al2O3. Microstructural characterization of the coatings was carried out by scanning electron microscopy (SEM) and X(ray diffraction. The tribological behavior of the coatings was investigated under dry sliding condition using linearly reciprocating ball-on-flat wear test. Both the PEO coatings exhibited a friction coefficient of about 0.8 and hybrid coatings exhibited a value of about 0.5 against the AISI 52100 steel ball as the friction partner, which were slightly reduced with the increase in applied load. The PEO coatings sustained the test without failure at 2 N load but failed at 5 N load due to micro-fracture caused by high contact stresses. The hybrid coatings did not get completely worn off at 2 N load but were completely removed exposing the substrate at 5 N load. The PEO coatings exhibited better wear resistance than the hybrid coatings and silicate PEO coatings exhibited better wear resistance than the phosphate PEO coatings. Both the PEO coatings melted/decomposed on laser irradiation and all the hybrid coatings exhibited similar microstructure and wear behavior irrespective of the nature of the primary PEO coating or laser energies. SEM examination of worn surfaces indicated abrasive wear combined with adhesive wear for all the specimens. The surface of the ball exhibited a discontinuous transfer layer after the wear test.

Explore related subjects

cond-mat.mtrl-sciphysics.app-ph

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

G. Rapheal, S. Kumar, C. Blawert, Narendra B. Dahotre. 2017-04-29. Wear-resistant thin films of MRI-230D-Mg alloy using plasma-driven electrolytic oxidation. https://doi.org/10.1016/j.wear.2010.12.013

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Incommensurate structural and magnetic modulations in potassium-rich cryptomelane, K$_x$Mn$_8$O$_{16}$ ($x\approx1.45$)

Cryptomelane is a hollandite-like material consisting of K$^+$ cations in an $α$-MnO$_2$ tunnel-like crystallographic motif. Cryptomelane with stoichiometry K$_x$Mn$_8$O$_{16}$ ($x\approx1.45$) has been synthesized and its magnetic properties investigated using variable-temperature magnetic susceptibility, heat capacity, and neutron powder diffraction. Three distinct transitions at $T_1=184$\,K, $T_2=54.5$\,K, and $T_3=24$\,K are observed. At $T_1$ there is a subtle tetragonal$\rightarrow$monoclinic transition associated with emergence of a set of non-magnetic superstructure peaks indexable to a $\vec{k}_\mathrm{struc}\approx0.74\vec{c^*}$ incommensurate modulation parallel to the $α$-MnO$_2$ tunnels. Our findings are consistent with a relation previously reported in titanate hollandites, that $x\approx2|\vec{k}_\mathrm{struc}|$. Magnetic Bragg peaks emerge below $T_2=54.5$\,K, and their positions indicate an incommensurate modulated magnetic structure. The model consistent with the data is a dual-$\vec{k}_\mathrm{mag}$ structure with a ferromagnetic $|\vec{k}_\mathrm{mag}|=0$ component and an incommensurate $\vec{k}_\mathrm{mag}\approx0.37\vec{c^*}$, with the latter most likely to be helical. The period of oscillation of the incommensurate magnetic component is in line with predictions based on a Heisenberg spin Hamiltonian [Mandal \textit{et al}. Phys. Rev. B 90, 104420 (2014)]. Below $T_3=24$\,K, there is a magnetic transition, which gives rise to a different set of magnetic Bragg peaks indicative of a highly complex magnetic structure.

cond-mat.mtrl-sci↗
arXiv2026

An anisotropic functional for two-dimensional material systems

Density function theory is the workhorse of modern electronic structure theory. However, its accuracy in practical calculations is limited by the choice of the exchange-correlation potential. In this respect, two-dimensional materials pose a special challenge, as all these materials and their heterostructures have a crucial similarity. The underlying atomic structures are strongly spatially inhomogeneous, implying that current exchange-correlation functionals, that in almost all cases are isotropic, are ill-prepared for an accurate description. We present an anisotropic screened-exchange potential, that remedies this problem and reproduces the band-gap of 2D materials as well as the piecewise linearity of the total energy with fractional occupation number.

cond-mat.mtrl-sci↗
arXiv2026

Thermally-driven reorientation of the Néel vector in altermagnetic MnTe

Altermagnets are novel magnetic systems that possess a spin-polarized electronic band structure without a net magnetic moment, making them promising for device applications. Hexagonal MnTe, a prototypical altermagnet, arguably exhibits the most properties consistent with theoretical predictions, including an anomalous Hall effect despite a vanishing net magnetization, and altermagnetinduced electronic band splitting. However, fundamental questions remain, including why some effects only appear significantly below the magnetic ordering temperature. Here, we resolve this discrepancy by revealing a reorientation of the Néel vector in single-crystalline MnTe. The Néel vector points 30° from the a-axis at low $T$, before aligning directly with the a-axis around $T\simeq 260$ K. We attribute this to single-ion anisotropy, which depends on temperature-dependent lattice parameters. We obtained these results using muon-spin spectroscopy, magnetization measurements, and X-ray diffraction; we show that the findings are consistent with neutron diffraction. Manipulating this effect, for example through strain, could unlock sensitive electronic detection schemes for external stimuli, paving the way for functional altermagnetic devices.

cond-mat.mtrl-sci↗