Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 2210.11687

Effect of Pressure on Electrical and optical Properties of Metal Doped TiO$_2$

Shashi Pandey·Alok Shukla·Anurag Tripathi
View original source ↗Read source document ↗Export metadata ↓

Abstract

A comparative study of the electrical and optical properties has been done on 3d-doped TiO$_2$. Ti$_{1-x}$M$_x$O$_2$ (M= Sc, V, Cr, Mn, Fe, Co, Ni, Cu, Zn) powder and its corresponding pellets, with doping concentration $x= 0.05$. The samples were prepared using the solid-state route. Optical and electrical measurements have been performed for all prepared samples and interestingly, it is observed that due to external pressure (i.e. strain) both the properties change significantly. A rigorous theoretical calculation has also been carried out to verify the experimental band gap obtained from optical absorption spectroscopy. In case of pellet sample band gap decreases as compared to the powder sample due to variation of pressure inside the structures. Role of doping has also been investigated both in pellet and powder forms and we found that the band gap decreases as the atomic number of dopants increases. A cross-over behavior is seen in pellet samples on doping with Ni, Cu and Zn (i.e. band gap increases with an increase in the atomic number of dopant). Electrical resistivity measurements have been carried out for both pellet and powder samples and it is found that in the case of strained samples the value of resistivity is smaller while in the case of strain-free samples it is quite large. We believe that the present study suggests a novel approach for tuning the electrical and optical properties of semiconducting oxides either from doping or from applied pressure (or strain).

Explore related subjects

cond-mat.mtrl-sci

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Shashi Pandey, Alok Shukla, Anurag Tripathi. 2022-10-21. Effect of Pressure on Electrical and optical Properties of Metal Doped TiO$_2$. https://doi.org/10.1016/j.optmat.2022.112875

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Towards ultra-scaled nanoelectronics using the zipper material system $Bi_2O_2Se/Bi_2SeO_5$

Two-dimensional (2D) materials could overcome the scaling bottleneck of nanoelectronics by enabling atomically thin channels, superior electrostatic control, and reduced short-channel effects. However, progress is limited by the lack of semiconductor–insulator interfaces being simultaneously scalable, stable, and reliable. Conventional 2D interfaces are often low quality or require transferring dissimilar materials, limiting reproducibility and scalability. We show that the zipper heterostructure formed by the high-mobility 2D semiconductor Bi 2 O 2 Se and its native high- κ oxide Bi 2 SeO 5 addresses these challenges, providing an atomically sharp, chemically matched interface with excellent electrostatics and promising scaling potential. We further present the first comprehensive multiscale assessment of Bi 2 O 2 Se/Bi 2 SeO 5 transistors targeting thermal stability, reliability, and scalability by linking atomic-scale structure and defects to device-level behavior across four transistor generations (top-gated, fin, and two gate-all-around architectures). Benchmarking against IRDS-2035 targets indicates that Bi 2 O 2 Se/Bi 2 SeO 5 devices could deliver high drive current with low gate leakage under aggressive scaling, potentially surpassing the targets in the upper-bound region of the sensitivity analysis. Finally, we identify oxygen-related oxide defects as the dominant origin of hysteresis consistent with a beneficial role of encapsulation and oxygen-rich annealing. Together, our findings support the potential of this zipper material system as a technologically-credible and manufacturing-relevant platform for future nanoelectronics.

cond-mat.mtrl-sci↗
arXiv2026

Influence of Heterogeneity on the Response of Architected Metamaterials

Architected metamaterials like foams and lattices exhibit complex responses governed by microstructural instabilities, localization, and phase-transition-like phenomena. Their behavior is further affected by heterogeneities inherent in their microstructure often caused through manufacturing processes. In this study we extend a gradient-enhanced, nonlocal continuum formulation to incorporate stochastic material heterogeneity through Gaussian random fields imposed on selected constitutive parameters. The framework enables independent control of both the amplitude and spatial correlation of material fluctuations while preserving thermodynamic consistency and regularization of localization. It also introduces a characteristic lengthscale ratio between the nonlocal and correlation lengthscales, that enables modeling at the limit of random or spatially correlated microstructures. Finite element simulations of confined compression and indentation show that heterogeneity fundamentally alters phase nucleation, localization morphology, and macroscopic response. Overall, the proposed framework provides a unified approach for linking stochastic material variability to instability-driven mechanics in architected metamaterials, enabling improved understanding of imperfection sensitivity, stability and design. It showcases how heterogeneity alone can influence characteristic features of the response, such as stability, slope of the plateau region, and elimination of the initial elastic regime.

cond-mat.mtrl-sci↗
arXiv2026

Structural, electronic, and optical properties of hexagonal GeSn from density functional theory

Unlike cubic GeSn, which undergoes an indirect-to-direct bandgap transition only above a finite Sn concentration, lonsdaleite (2H) germanium is an intrinsic direct-gap semiconductor. We employ first-principles density functional theory to investigate the structural, electronic, and optical properties of 2H-Ge$_{1-x}$Sn$_{x}$ random alloys in the dilute Sn regime ($x \le 0.10$). Substitutional disorder is modeled using 48-atom special quasirandom structure (SQS) supercells, and the coherent effective band structure is recovered via spectral band unfolding. We show that the semiconducting alloy configurations retain a direct bandgap at the $Γ$ point, with a moderate, nearly linear reduction of the bandgap in the dilute regime that shifts the fundamental absorption edge toward the mid-infrared. As the gap approaches zero, its calculated value becomes increasingly sensitive to the atomic configuration and supercell size. Evaluation of the optical transition matrix elements shows that the polarization anisotropy characteristic of pristine 2H-Ge remains observable under dilute Sn alloying. Although alloy disorder relaxes the crystal selection rules, the band edge response remains dominated by light polarized perpendicular to the crystal $c$ axis, whereas the parallel component remains weaker. These results identify dilute hexagonal GeSn as a tunable direct-gap system with a strongly polarization-dependent optical response in the infrared.

cond-mat.mtrl-sci↗