Search arXiv⌕ Search
Home/Archive/arXiv

arXiv · 2310.07273

Paste Rheology and Surface Charge of Calcined Kaolinite

Yannick Demeusy·Sandrine Gauffinet·Christophe Labbez
View original source ↗Read source document ↗Export metadata ↓

Abstract

Partial substitution of the clinker in the cement by a supplementary cementitious material (SCM) is one of the main solutions to reduce the carbon footprint. Calcined kaolinite is a good candidate due to its availability and relatively high reactivity compared to other SCMs. The main issue with these calcined clay types of cements is the high-water demand at low clinker factors, a problem which remains not well understood. In this proceeding, we will show the role played by electrostatic interactions in the paste stiffening using as a model system pure calcined kaolinite paste prepared at various pH as well as salt types and concentrations. The study combines dynamic rheometry measurements in strain-sweep modes, surface charge characterization using potentiometric titration and electrophoretic measurements as well as calculations of inter-particle interactions using Monte-Carlo (MC) simulations in the framework of the primitive model. The calcined kaolinite is found to possess a negative permanent charge, presumably due to the Si(IV)/Al(III) substitution, and a titratable charge (as due to ionization of silanol and aluminol surface groups) with a point of zero proton charge at pH 4.65. In conditions relevant for cement paste, the calcined clay bear a strong negative charge ~ 300 mC/m2. The rheological measurements reveal that the paste stiffening is highly dependent on the pH, salt concentration and type as expected for systems controlled by electrostatic interactions. The stiffness increases with the salt concentration at natural pH and is the largest in solutions buffered with Ca(OH)2, that is at high Ca2+ concentrations and pH where the negative charge of the calcined clay is the strongest. The MC simulations of the inter-particle interactions are found to qualitatively explain the observed variation in the paste stiffness.

Explore related subjects

cond-mat.mtrl-sci

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Yannick Demeusy, Sandrine Gauffinet, Christophe Labbez. 2023-10-11. Paste Rheology and Surface Charge of Calcined Kaolinite. https://arxiv.org/abs/2310.07273

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Towards ultra-scaled nanoelectronics using the zipper material system $Bi_2O_2Se/Bi_2SeO_5$

Two-dimensional (2D) materials could overcome the scaling bottleneck of nanoelectronics by enabling atomically thin channels, superior electrostatic control, and reduced short-channel effects. However, progress is limited by the lack of semiconductor–insulator interfaces being simultaneously scalable, stable, and reliable. Conventional 2D interfaces are often low quality or require transferring dissimilar materials, limiting reproducibility and scalability. We show that the zipper heterostructure formed by the high-mobility 2D semiconductor Bi 2 O 2 Se and its native high- κ oxide Bi 2 SeO 5 addresses these challenges, providing an atomically sharp, chemically matched interface with excellent electrostatics and promising scaling potential. We further present the first comprehensive multiscale assessment of Bi 2 O 2 Se/Bi 2 SeO 5 transistors targeting thermal stability, reliability, and scalability by linking atomic-scale structure and defects to device-level behavior across four transistor generations (top-gated, fin, and two gate-all-around architectures). Benchmarking against IRDS-2035 targets indicates that Bi 2 O 2 Se/Bi 2 SeO 5 devices could deliver high drive current with low gate leakage under aggressive scaling, potentially surpassing the targets in the upper-bound region of the sensitivity analysis. Finally, we identify oxygen-related oxide defects as the dominant origin of hysteresis consistent with a beneficial role of encapsulation and oxygen-rich annealing. Together, our findings support the potential of this zipper material system as a technologically-credible and manufacturing-relevant platform for future nanoelectronics.

cond-mat.mtrl-sci↗
arXiv2026

Influence of Heterogeneity on the Response of Architected Metamaterials

Architected metamaterials like foams and lattices exhibit complex responses governed by microstructural instabilities, localization, and phase-transition-like phenomena. Their behavior is further affected by heterogeneities inherent in their microstructure often caused through manufacturing processes. In this study we extend a gradient-enhanced, nonlocal continuum formulation to incorporate stochastic material heterogeneity through Gaussian random fields imposed on selected constitutive parameters. The framework enables independent control of both the amplitude and spatial correlation of material fluctuations while preserving thermodynamic consistency and regularization of localization. It also introduces a characteristic lengthscale ratio between the nonlocal and correlation lengthscales, that enables modeling at the limit of random or spatially correlated microstructures. Finite element simulations of confined compression and indentation show that heterogeneity fundamentally alters phase nucleation, localization morphology, and macroscopic response. Overall, the proposed framework provides a unified approach for linking stochastic material variability to instability-driven mechanics in architected metamaterials, enabling improved understanding of imperfection sensitivity, stability and design. It showcases how heterogeneity alone can influence characteristic features of the response, such as stability, slope of the plateau region, and elimination of the initial elastic regime.

cond-mat.mtrl-sci↗
arXiv2026

Structural, electronic, and optical properties of hexagonal GeSn from density functional theory

Unlike cubic GeSn, which undergoes an indirect-to-direct bandgap transition only above a finite Sn concentration, lonsdaleite (2H) germanium is an intrinsic direct-gap semiconductor. We employ first-principles density functional theory to investigate the structural, electronic, and optical properties of 2H-Ge$_{1-x}$Sn$_{x}$ random alloys in the dilute Sn regime ($x \le 0.10$). Substitutional disorder is modeled using 48-atom special quasirandom structure (SQS) supercells, and the coherent effective band structure is recovered via spectral band unfolding. We show that the semiconducting alloy configurations retain a direct bandgap at the $Γ$ point, with a moderate, nearly linear reduction of the bandgap in the dilute regime that shifts the fundamental absorption edge toward the mid-infrared. As the gap approaches zero, its calculated value becomes increasingly sensitive to the atomic configuration and supercell size. Evaluation of the optical transition matrix elements shows that the polarization anisotropy characteristic of pristine 2H-Ge remains observable under dilute Sn alloying. Although alloy disorder relaxes the crystal selection rules, the band edge response remains dominated by light polarized perpendicular to the crystal $c$ axis, whereas the parallel component remains weaker. These results identify dilute hexagonal GeSn as a tunable direct-gap system with a strongly polarization-dependent optical response in the infrared.

cond-mat.mtrl-sci↗