Sub 35-ps Single-Photon Stellar Intensity Interferometry of Vega

Verena G. Leopold; Sebastian Karl; Stefan Richter; Jean-Pierre Rivet; Yury Prokazov; Evgeny Turbin; Gennady Sintotskiy; Iurii Datii; Jason Aufdenberg; Joachim von Zanthier

arXiv · 2610.06335

Sub 35-ps Single-Photon Stellar Intensity Interferometry of Vega

Verena G. Leopold·Sebastian Karl·Stefan Richter·Jean-Pierre Rivet·Yury Prokazov·Evgeny Turbin·Gennady Sintotskiy·Iurii Datii·Jason Aufdenberg·Joachim von Zanthier

View original source ↗Read source document ↗Export metadata ↓

Abstract

SII enables measurements of stellar photospheres by correlating intensity fluctuations, offering a robust alternative to amplitude-based techniques. With the advent of modern single-photon counting detectors, this method has re-emerged as a powerful technique in stellar interferometry exploiting their ultra-high timing resolution. We determine the stellar diameter of Vega at 405 nm using spatial intensity correlations measured at the C2PU facility, part of the Observatoire de la Cote d'Azur. We employed a setup identical to Leopold et al. (2025). The two campaigns in April and August 2024 used hybrid photodetectors (HPDs; 22.7 ps resolution) and new PhotonPix detectors (34.8 ps resolution). A Photonscore TDC integrated photon arrival times and IRIG-B timestamps for synchronization. Our analysis consisted of calculating auto- and cross-correlation histograms from the recorded data, which were then normalized and corrected for optical path differences. The temporal auto-correlations yield a consistent coherence time of 0.21 ps. This confirms the effectiveness of the PhotonPix detectors despite a slight degradation in timing resolution relative to the HPDs. Combining the data from the two measurement campaigns yields a uniform disk diameter of Vega of 2.97 +/- 0.23 mas. This agrees with the 3.047 mas diameter predicted by the stellar atmosphere model at our observation wavelength, validating our technique and the new PhotonPix detectors for precision SII at sub-35 ps resolution. The integration of advanced single-photon detectors like the PhotonPix into existing IACT SII instruments promises substantial enhancements in signal-to-noise ratio and observational capabilities, particularly with CTA LSTs. Although challenges such as night sky background saturation and precise positioning and guiding remain, SII observations at apparent magnitudes up to 7.8 are within reach.

Explore related subjects

astro-ph.IM astro-ph.SR

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Verena G. Leopold, Sebastian Karl, Stefan Richter, Jean-Pierre Rivet, Yury Prokazov, Evgeny Turbin, Gennady Sintotskiy, Iurii Datii, Jason Aufdenberg, Joachim von Zanthier. 2026-10-05. Sub 35-ps Single-Photon Stellar Intensity Interferometry of Vega. https://arxiv.org/abs/2610.06335

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

A chemically etched D-band waveguide orthomode transducer for CMB measurements

This study presents a prototype D-band waveguide orthomode transducer (OMT) fabricated using chemically etched brass platelets. This method offers a fast, cost-effective, and scalable approach for producing waveguide OMTs above 100 GHz, making it well-suited for current and future Cosmic Microwave Background polarization experiments, where large focal planes with thousands of receivers are required to detect the faint primordial \textit{B}-modes. Chemical etching has already demonstrated its effectiveness in manufacturing corrugated feedhorn arrays with state-of-the-art performance up to 150 GHz. Here, we evaluate its applicability to more complex structures, such as OMTs. We designed a single OMT prototype operating in the 130-170 GHz range, fabricated by chemically etching 0.15 mm-thick brass plates, which were then stacked, aligned, and mechanically clamped. Simulations based on metrological measurements of the OMT profile predict return losses below $-$10 dB, isolation better than $-$30 dB, and transmission around $-$0.5 dB. The measured transmission and isolation, however, is around $-$1.5/$-$2 dB and $<-$20 dB, respectively. Further simulations show that the degradation in the transmission is related to defects and roughness along the etched profile ($\mathrm{RMS}\simeq$3 $μ$m), which is a typical and unavoidable effect of chemical etching. The discrepancy in isolation, instead, could arise from a slight rotation ($\sim$3$^{\circ}$) of the polarization angle within the measurement chain. Our results show that chemical etching is a fast, low-cost, and scalable technique for producing waveguide OMTs with state-of-the-art performance in terms of return loss and isolation. However, at frequencies above 100 GHz the transmission coefficient may degrade due to the mechanical precision limitations of chemical etching.

astro-ph.IM↗

arXiv2026

On the Nonlinear Dependence of Underground Muon Rate on Atmospheric Temperature Observed at Daya Bay

The underground cosmic-ray muon rate is modulated by atmospheric temperature. It can be explained by the theories of Barrett, Gaisser, and others. However, the Daya Bay Neutrino Experiment observes a nonlinear temperature dependence. We find that, when deriving the temperature dependence of the muon rate, existing theories consider only the impact of the local temperature on muon production at the layer where muons are produced. In this work, we provide a more general solution to the cascade equations that fully depicts how the entire temperature profile influences the final muon rate. The corresponding definitions of the effective temperature weight and temperature coefficient are also presented. We have examined the results using the numerical tool MCEq with real atmospheric temperature inputs. A linear modulation is recovered and verified. This work can help explain the nonlinear effect observed at Daya Bay and provide a more refined theoretical framework for calculating the temperature coefficient in other experiments.

astro-ph.IM↗

arXiv2026

A space of inference spaces in the space sciences - parametric Bayesian inference in astronomy, cosmology and particle physics

A sample of parametric Bayesian inference applications from astronomy, cosmology and particle physics is studied, augmented by mock data sets and toy problems. The parameter spaces of these parametric physical models and their posterior distributions from analysing specific data are characterized by (1) the number of model parameters, (2) whether the posterior shape is similar to a Gaussian, (3) whether the posterior has light or heavy tails, (4) how small the posterior is compared to the prior, i.e., how informative the data are, (5) whether some parameters remain unconstrained while others are highly constrained, (6) whether the posterior has multiple, disconnected modes, and (7) whether the inference undergoes phase transitions. These axis define a parameter space of inference problems. We characterize each of the inference problems and observe that inference in astrophysics spans the entire parameter space, from low to high dimensionality, mono- to multi-modal, and a variety of complex distributions that range from uninformative to highly informative. Furthermore, the computational cost of the physical models can range from milliseconds to dozens of seconds. The collated sample of inference problems is proposed as a standard test bed for new samplers. For reproducibility and ease of use, a Docker compute image is provided.

astro-ph.IM↗